Chipolino DUO SMART User manual

This child restraint system is manufactured in
compliance with the requirements of Regulation No 129/03 of the Economic
Commission for Europe of the United Nations (UN/ECE) — Uniform provisions
concerning the approval of enhanced Child Restraint Systems used on board of
motor vehicles (ECRS), the provisions of the Product safety Directive 2001/95/
EU of the European Parliament and The Council as well as the Consumer
Protection Law of Bulgarian Legislation.
IMPORTANT! KEEP THIS MANUAL FOR FUTURE REFERENCE!
INSTRUCTION MANUAL FOR
USE OF CHILD RESTRAINT SYSTEM
MODEL „DUO SMART”

!
1
Child restrained system „DUO SMART” is approved according to Regulation R129/03 and complies
with the following requirements:
• It is installed in REARWARD FACING position and using the 3-point vehicle belt
• Children height 40-87 cm
•Weight ≤13 kg
N O T I C E
regarding Universal Belted category Enhanced Child Restraint Systems (40-87 cm).
This is Universal Belted Enhanced Child Restraint System.
It is approved according to UN Regulation No. 129, for use primarily in “Universal seating
positions” as indicated by vehicle manufacturers in the vehicle user’s manual.
If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer.
DO NOT FORGET THAT NO RESTRAINT SYSTEM
CAN PROVIDE ABSOLUTE PROTECTION IN CASE
OF A CRASH OR ROAD ACCIDENT!
IN ORDER TO ENSURE THE SAFETY OF YOUR CHILD, FOLLOW
EXACTLY THE INSTRUCTIONS AND SAFETY RECOMMENDATIONS
IN THIS MANUAL!
MISUSE OF THE CAR SEAT WILL CONTRIBUTE TO REDUCING
ITS SECURITY AND SAFETY FEATURES! FAILURE OF THE
GUIDELINES OF THIS INSTRUCTION INCREASES THE
RISK OF SERIOUS INJURY OR DEATH!
WARNING!
1. DO NOT PLACE THE RESTRAINT SYSTEM ON A VEHICLE SEAT EQUIPPED WITH AIR
BAG! THIS MAY RESULT IN DEATH OR SERIOUS! Review the instructions of the vehicle for
information about airbags and conditions of transportation of children.
2. DO NOT USE ANCHOR POINTS OTHER THAN THE ONES DESCRIBED IN THIS MANUAL
AND MARKED ON THE RESTRAINT SYSTEM!
This car seat is suitable for installing only
in vehicles equipped with 3-point safet
belts, approved by Regulation №16
Economic Commission for Europe of the
United Nations.
A – diagonal belt
B – lap belt
Correct installation
Wrong installation
lap belt and
diagonal belt
lap
belt
A
B

A
B
2
WARNING! NEVER LEAVE YOUR CHILD UNATTENDED!
WARNING! DO NOT USE ANCHOR POINTS OTHER THAN THE ONES DESCRIBED IN THIS
MANUAL AND MARKED ON THE RESTRAINT SYSTEM.
WARNING! NEVER PLACE THE CAR SEAT ON PASSENGER SEAT, EQUIPPED WITH
ACTIVATED AIRBAG! THIS MAY LEAD TO SERIOUS INJURY OR DEATH!
WARNING! THE VEHICLE SAFETY BELTS WHICH HOLD THE CAR SEAT TO THE PASSENGER
SEAT MUST BE TIGHTENED AND FIXED!
WARNING! THE CAR SEAT SAFETY BELTS MUST BE PROPERLY ADJUSTED ACCORDING
TO CHILD’S HEIGHT, NOT TWISTED AND SNUG WELL AGAINST BABY’S BODY.
THE LAP BELT MUST BE PLACED LOW DOWN, SO THAT THE PELVIS IS FIRMLY ENGAGED
WITHOUT PRESSING!
WARNING! DO NOT MAKE CHANGES, ADDITIONS OR MODIFICATIONS ON THE CAR SEAT
WITHOUT THE APPROVAL OF THE NOTIFYING AUTHORITY ! IT IS DANGEROUS NOT
TO KEEP STRICTLY THE INSTRUCTIONS GIVEN BY THE MANUAFACTURER!
In order to assure maximum protection, please read carefully the manual and install and use the car
seat as described.
WARNING! KEEP AWAY FROM FIRE!
Use this car seat only in REWARD FACING position and for children with eight 40-87cm and weight
 upto13kg.
ALWAYS fasten the child in the car seat with the 3-point belt.
Installation in the vehicle and securing the child in the car seat to be done only by adult!
The hard parts and the parts of the child restraint made of plastic should be located and installed
so that when the vehicle is in normal use, they can not be trapped by a sliding seat or in a door of
the vehicle.
Do not allow the safety belts of the car seat and the vehicle to be twisted, frayed or torn, latches and
 locks(buckles)mustbealwaysingoodorderandrmlyxed.
 Ifyounduncertaintyordefectinthestructure,latches,strapsorlockingmechanismsofthecar
seat, discontinue usage until removal of the damaged parts and replacement with new ones.
Not allowed installation
Allowed installation
Do not install the car seat on a vehicle seat equipped with activated air bag.
Install the car seat on vehicle seat equipped with 3-point belt.
CAUTION! WARNINGS!

3
In case of a car accident, the child restraint system and its belts may be damaged, therefore,
it is recommended to replace it with a new one.
 Neverusesecondhandchildrestraint.Itmayhavesu󰀨eredstructuraldamage,whichmaymake
the child restraint extremely dangerous.
Do not use this car seat without its seat cover and do not replace it with a new one, unless supplied
by the manufacturer. The fabric parts are integral parts of the restraint system and its safety
features!
Any luggage or other objects that could cause injury in the event of a collision must be well secured.
Remove or secure at a safe distance from the seat and child any luggage that may cause injury
in the event of a sudden stop or accident while driving.
 Alwayscheckthattheseatis rmlyattachedtothevehicleseat,even whenyouarenotplacing
a child in it. A loose car seat, even without a child in it, can cause injury in the event of a collision.
NEVER adjust or move any moving parts of the car seat while there is child in it.
Do not put additional pads except the ones supplied from the manufacturer!
Do not use spare parts and other components not supplied by the manufacturer. The manufacturer
assumes no responsibility for safety in the event that are used spare parts other than original.
Keep the instructions for use in the space provided in the car seat or in the vehicle in which you are
going to use the car seat.
Do not expose the car seat to direct sunlight to prevent the child from burning, deforming the car seat
and especially the plastic parts.
The car seat does not replace the child's cot or bed. When a child needs a sleep, you have to place
him/her in a suitable baby stroller, baby crib or bed.
Do not attach objects with long cords or strings on the car seat in order to avoid danger of
 su󰀨ocation!
Never place the car seat on beds, couches or similar soft surfaces!
Do not allow children to play with the product!
 Donotremovestickersandwarnings–theycontainimportantinformation!
 The packaging of the product must be kept out of the reach of children at the time of and after
 unpackinginordertoavoidtheriskofstrangulation!

4
MAIN PARTS
INSTRUCTIONS FOR USE OF THE CHILD RESTRAINT SYSTEM
PRODUCT FEATURES
Universal Belted Enhanced Child Restraint System. Suitable for children with height 40-87 cm and
 weight≤13kg.
 Headrestandshoulderbeltsheightadjustmentin6positions;
 3-pointsafetybelt;
 Additionalnewbornpadforchildrenwithheight40-75cm;
IMPORTANT!
• Follow exactly the instructions and sequence of installation steps and use of the product described
inthetextandguresofthismanual.
•Checkthesecurityofxingaftereachoperation!
• ALWAYS CHECK THE SECURITY OF FIXING OF THE SAFETY BELTS!
•Aftereachinstallationmakesurethattheseatbeltsarenottwistedandtheyareinthecorrect
position.
Handle
Body
Headrest
Canopy frame
Central buckle
Crotch belt
Handle position
adjustment button
Diagonal
belt guide
Belts
openings
Lap belt guide
Shoulder belts pads
Headrest height
adjustment button
Newborn pad
(children height: 40-75 cm)
Shoulder belts length adjustment
button (under the PRESS label)
Shoulder belts
Crotch pad
Belt length
adjusting strap

5
Theheadrestandshoulderbeltsheightmaybeadjustedin6positions.
Pressthebutton(Press)andpullouttheshoulderbeltsinordertoloosenthem(a).
Press the head rest height adjustment button (b) and move it up or down to your desired position.
Releasethebuttoninordertoxtheheight.Whenthepositionisxedyouwillhearaclick.
ATTENTION!Checkiftheheadrestisxedbytryingtoslideitdown.
IMPORTANT!Alwaysmakesurethattheshoulderbeltsareatthecorrectheightforyourchild.
Belts must go through the openings of the fabric cover and car seat, located closest to child’s shoulders.:
1. HEAD REST AND SHOULDER BELTS HEIGHT ADJUSTMENT
NO
Too low
click
YES
Too high
NO
Suitable height
a
b

6
4. NEWBORN PAD
The newborn pad is suitable for children with height 40 - 75 cm.
Place the pad in the car seat. Thread the shoulder belts above the pad as shown in the picture.
Threadthecrotchbeltwiththecentralbucklethroughtheopeninginthelowerpartofthepad.
To remove the pad, repeat the actions in reverse order.
Step 1:
Pressthebeltslengthadjustmentbutton–locatedunderthe
„PRESS“ label and at the same time grab the belts as shown
inthegure.
Step 2:
Pull out the shoulder belts while holding the button pressed in
order to loosen them.
Pull the strap in order to tighten the belts.
IMPORTANT! Belts must hug the child’s body without causing
pressure or discomfort.
Note:Always check and tighten the belts when placing the
child in the car seat.
2. LOOSENING THE SHOULDER BELTS
3. TIGHTENING THE SHOULDER BELTS

7
Beforeplacingthechildinthecarseatyoumustloosentheshoulderbelts(Seesection2),adjustthe
headrestandshoulderbeltsheight(Seesection1)andplacethenewbornpad(Seesection4).
Presstheredbuttononthecentralbuckle(a),inordertounfastenthebeltsandputthemaside(b).
Placethechildinthecarseatandtheshoulderbeltsonhisshoulders(c).
Jointhetwometalendsandinserttheminthecentralbuckle(d).Whenxedyouwillhearaclick.
IMPORTANT!Makesurethebeltendsarewellxedinthebucklebytryingtopullthebeltsup(e).
Totakethechildoutoftheseat,repeatthesameactionsinreverseorder.
a
d
e
b c
5. SECURING THE CHILD IN THE CAR SEAT
click

8
6. HANDLE ADJUSTMENT
7. CANOPY INSTALLATION
Press the buttons on both sides of the handle and
move the handle.
The handle may be placed in 4 positions:
1–PositionFORWARD(suitableforinstallingthecarseatinthevehicleinposition„REARWARD“).
2–PositionUP(suitabletocarrythecarseat).
3–PositionBACK(suitabletousewhencarseatisusedascradle).
4–PositionDOWN(suitableforwhenyoufeedthebabyorplaywithit).
ATTENTION!Makesurethatthehandleiswellxedandthebeltisfastenedbeforeeachuse!
1
1
3
5
2
4
6
2 3 4

9
MovethehandletopositionBACK,asshowningure .
Insert the canopy frame in the fabric.
Insert both ends of the canopy in the corresponding openings.
 Fixtheedgeofthecanopytothecarseatasshowninthegure.
Open the canopy by pulling it to the front.
 Movethehandletothedesiredpositionasdescribedinsection6„Handleadjustment“.
To remove the canopy repeat the same actions in reverse order.
8. SECURING THE CHILD IN THE CAR SEAT WITH THE 3-POINT VEHICLE SAFETY BELT
WARNING! Do not install the car seat on a vehicle seat equipped with activated air bag!
WARNING! This child restraint system may be installed only using 3-point vehicle belt
(diagonalandlapbelts).
WARNING!Alwaysinstalltheseatin„REARWARD“position(facingthebackofthevehicle).
Step 1 Step 2
Step 3 Step 4
Step 5 Step 6
A
1
3
4
5
6
2
click

10
Step 1: Place the child in the car seat. Fasten and adjust the 3-point safety harness. Adjust the handle
inpositionUP.PlacethecarseatonthevehicleseatinREARWARDfacingpositionandmakesurethat
itisrmlypressedagainstthevehicleseat.
Step 2:Threadthevehiclelapbeltthroughthelapbeltguides.Fastenthebeltinthevehiclebeltbuckle
(click).Pullthediagonalbeltinthedirectionshowninthepictureinordertotightenit.
Note:Makesurethatthebeltiswellfastenedbytryingtopullit.
Step 3:Threadthediagonalvehiclebeltthroughthediagonalbeltguidelocatedonthecarseatback.
Step 4: Tighten the vehicle belt by pulling in the direction shown in the picture.
Step 5: Move the handle in position FORWARD.
Note:Makesurethatthehandleisrmlypressedagainstthevehicleseatbackrest.
Thecorrectbucklepositionisshowninpicture5-A.
Step 6:
WARNING!Thevehiclebelt(lapanddiagonal)mustbewelltightenafterthecarseatisinstalled!
IMPORTANT!Makesurethatthebeltiswellxedandisnottwisted(g.5А).
IMPORTANT!Makesurethatfabricdoesnothinderthemovementortighteningofthebelt.
To remove the car seat from the vehicle seat repeat the described actions in reverse order.

11
CARE AND MAINTENANCE
Clean the fabrics, plastic parts and metal parts with damp cotton cloth or sponge and mild soap
 Fabriccoverandsoftpadsmaybehandwashedat30Сusingmilddetergent!
Do not bleach! Do not tumble dry! Do not machine wash! Do not iron!
Do not use abrasive, bleach or other aggressive detergents.
Always after cleaning leave the car seat fully dry and after that use it or store it.
Harnesses must be cleaned with damp cloth and mild soap!
 Donotwetorremovethestickers.Theycontainimportantinformation!
 Alwaysstoreyourcarseatindoors–ondryandcleanplace.Donotexposetodirectenvironment
 inuence-sun,rain,moistureandhightemperatureintervals.
Please, contact your authorized dealer for problems connected with the use or repair.
Fabric:
Outer: 100% polyester
Filling: 100% polyester
Materials used: plastic, metal, textile.
STKDS02хххх

Bulgaria, Plovdiv, Golyamokonarsko shosse № 1
www.chipolino.com