Citizen Miramar,- FB1180-56D User manual

H501 Movement Caliber Setting Instruction Addendum
The “Chronograph Zero Position” setting instruction as outlined on page 21 of the setting
instructions is incorrect. Outlined below is the correct procedure.
[Chronograph Second Hand Zero Positioning]
1. Pull the crown out to the time correction
position.
2. Press button (A) for 3 seconds or more and
release it, the watch enters the
‘chronograph second 0-position correction’
mode. (this step was omitted from the
original instructions)
3. Press button (A) to position the
chronograph second hand at the 0-seconds
position.
• The chronograph second hand can be
advanced one second at a time (in the
clockwise direction) each time button (A)
is pressed.
• The chronograph second hand can be
advanced rapidly by pressing button (A)
continuously.
4. Once the chronograph second hand has been positioned at the ‘0’ position,
reset the time and return the crown to the normal position.
5. Press button (B) to check that the chronograph minute hand has been reset to
the ‘0’ position.