Clear One COLLABORATE Live 300 User manual

COLLABORATE® Live 300
Quick-Start Guide
QSG-0073-001v1.1 April 2023

COLLABORATE® Live 300
Page 1 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Notices
© 2023 ClearOne, Inc. All rights reserved.
Information in this document is subject to change without notice.
Document: QSG-0073-001v1.1 April 2023
ClearOne®Contacts
Headquarters Headquarters
5225 Wiley Post Way Suite 600 Tel: +1.801.975-7200
Salt Lake City, UT 84116
Sales Technical Support
Tel: [phone] Tel: [phone]
[email protected] [email protected]

COLLABORATE® Live 300
Page 2 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Components Included
COLLABORATE Live 300
No Description Products
1 COLLABORATE Live 300
codec with power supply,
VESA Mounting Plate, and
COLLABORATE Remote
Control with USB dongle
2 910-2100-012
UNITE 160 4K camera,
power supply, USB cable
Note: The remote control
inside the camera box is
only for any advanced con-
figuration in the camera, if
required.
For the camera’s control, use
the COLLABORATE Codec
Appliance’s remote control.
3 910-3001-200
CHAT 150C with USB cable

COLLABORATE® Live 300
Page 3 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Connecting Peripherals
Connect the CHAT 150C, UNITE Camera, monitor(s), and network to the COLLABORATE Live 300
codec as shown.
Connecting Remote Control Dongle
Install batteries in the remote control and plug in the USB dongle into the codec.
HDMI 1080P or 720P
Video/Audio Out (for
Primary Monitor)
Mini Display
Port (for 2nd
Monitor)
Ethernet
Connection
to Network
DC In
USB Port for
UNITE Camera
USB 3.0 Port for
CHAT 150C
DC In
Note: To maximize range of the remote, verify that the dongle and the UNITE camera USB are
plugged into opposite sides of the codec.
7.1 digital L+R
audio output jack
Remote control
dongle only

COLLABORATE® Live 300
Page 4 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Security
A lock support feature allows you to secure your codec.
Configuring Display Settings
Once COLLABORATE Live is loaded, the Setup Wizard appears. The Setup Wizard lets you
configure the system name, time, and network, proxy, settings. After the Setup Wizard is complete,
using the remote control, navigate to the display settings:
Settings > Advanced > Display
According to your monitor capabilities, set to the maximum supported resolution. If 2 monitors are
connected to the unit, the display mode is automatically changed to dual mode and you can set both
monitors’ resolutions.
SD Card Slot
(Do Not Use)
Lock Support

COLLABORATE® Live 300
Page 5 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Configuring Audio Settings
The COLLABORATE Live 300 audio input and output are set to the CHAT 150C.
Verify this in COLLABORATE Settings > Audio & Video

COLLABORATE® Live 300
Page 6 QSG-0073-001v1.1 April 2023
Quick-Start Guide
Configuring Network Settings
Using your remote control, navigate into the network settings:
Settings > Advanced > Network
The COLLABORATE Live 300 obtains its IP automatically by default from a DHCP server.
Set “Obtain Address From DHCP” to “Disabled” to manually configure network settings.