Clearaudio Charisma V2 MM User manual

clearaudio
Charisma V2 MM
© clearaudio electronic GmbH Made in Germany
User manual
Bedienungsanleitung

Page 2 © clearaudio electronic GmbH
User manual / Bedienungsanleitung
User manual ....................................2 – 11
Bedienungsanleitung ......................12 - 21
Dear audio enthusiast,
each component part that makes up a Clearaudio V2 MM cartridge
is measured analysed and hand-selected, as is the nal, completed
cartridge. Every cartridge is 100% “Made in Germany” by Clearaudio’s
own dedicated in-house team, thus ensuring its uniqueness and quality.
From the concept V2 to the Maestro V2, our MM cartridges have long
been at the forefront of the moving magnet eld and have proved popular
among music lovers for their distinctive high quality.
The Charisma V2 is the new agship of the Clearaudio MM cartridge
range. Only the nest materials qualied for inclusion, including the same
diamond-coated Boron cantilever found in our world-leading Goldnger
Statement MC cartridge.
The use of highly ecient magnets gives the dynamic Charisma V2 an
almost record-breaking output, easily enough to amply drive less sensitive
phono stages.
The double-polished diamond stylus is mounted on the cantilever with
matchless precision, ensuring excellent frequency response and the
highest channel separation. The cartridge body is made from the nest
ebony wood and is set with a German silver inlay.

Made in Germany Page 3
User manual / Bedienungsanleitung
Please note:
This user manual gives you valuable information for the correct installation
of your cartridge. For ne adjustment, however, we can only provide
general guidelines, since the optimal adjustment depend primarily on your
specic tonearm and turntable.
Many thanks again for choosing Clearaudio.
We wish you much musical enjoyment with your new Charisma V2 MM
cartridge.
Clearaudio electronic GmbH
CAUTI ON:
NOT SUI TABLE FOR SHELLAC RECORDS (78rpm).
This phono cartridge is only for mounting on tonearms and must
not be used for other purposes.

Page 4 © clearaudio electronic GmbH
User manual / Bedienungsanleitung
Contents
1. I ncluded accessories..............................5
2. Mounting procedure ...............................6 - 7
3. Adjustment of the tracking force ...........8
4. Special instructions................................9 - 10
5. Technical data ........................................11
Warranty information.................................22 - 23

Made in Germany Page 5
User manual / Bedienungsanleitung
1. I ncluded accessories
• Allen key 2mm
• Cartridge mounting screws (2pcs. M2.5 x 10mm; 2 pcs. M2.5 x 8mm)
• User manual
Additional analogue accessories are available at: www.analogshop.de
The following are recommended:
• Clearaudio Test Record (Art. No. LP43033)
• Clearaudio Break-In Test Record (Art. No. BIN070904)
• Clearaudio Setting Template (Art. No. AC005/ IEC).
• Clearaudio Stylus Gauge (Art. No. AC094)
• Clearaudio Weight Watcher touch (Art. No. AC163)
• Clearaudio Elixir of Sound (Art. No. AC003)
• Clearaudio Diamond cleaner brush (Art. No. AC014)

Page 6 © clearaudio electronic GmbH
User manual / Bedienungsanleitung
2. Mounting procedure
Take the cartridge out of the packaging. To avoid damage, we recommend
leaving the stylus guard on the cartridge while mounting the cartridge
onto the tonearm.
Use the screws provided to mount your Clearaudio Charisma V2 MM
cartridge (the cartridge threads in the body comply with the metric
standard for M 2.5mm screws and have the standard spacing of 12.7mm).
Be careful not to over-tighten the screws as they may strip the
threaded holes.
Now connect the pins of your Clearaudio cartridge to the jacks of the
headshell or tonearm cable, taking care not to use too much force.
If necessary, you can use suitable precision pliers or tweezers for
assistance.
Please note the colour coding below in order to ensure the correct phase
in music playback, otherwise an audible sound deterioration would result.
Pic. 1: Colour marking of the signal pins
+
-
LR
Left output (L+ ) > > white
Left ground > > blue
Right output (R+ ) > > red
Right ground > > green

Made in Germany Page 7
User manual / Bedienungsanleitung
We recommend the following order of assembly:
1. Mount the Charisma V2 MM cartridge into the tonearm.
2. Connect the tonearm or turntable ground with the preamplier
ground (before plugging in the electrical power supply).
3. Plug the tonearm cable into the phono inputs of your
preamplier.
4. Turn down the volume control to a minimum position
(position 0).
5. Plug the mains power cord into your electrical power supply.
Our tip for mounting the cartridge:
Choose a bright workplace and good tools, and take your time so you can
concentrate.

Page 8 © clearaudio electronic GmbH
User manual / Bedienungsanleitung
3. Adjustment of the tracking force
Carefully remove the stylus guard from the cartridge by grasping it with
your thumb and forenger and gently pulling it forward.
The correct tracking force of your cartridge can be found in the technical
data in this user manual. Please only use these values, since if the tracking
force is too light (1g or less) the cartridge could jump out of the record
groove and damage the needle.
However, you should never set a tracking force of more than 5g as this
could cause damage to the diamond and thus to the cartridge.
In the event that it is not possible to set the optimal tracking force due
the cartridge being too light, you should use a spacer plate available from
your Clearaudio importer/dealer.
Further valuable information for the correct adjustment of your cartridge
can be found in the respective user manual of the turntable and/ or
tonearm manufacturer.

Made in Germany Page 9
User manual / Bedienungsanleitung
4. Special instructions
• Before playing a record, please remove all dust and dirt from the
record’s surface using a quality cleaning device. For the best results, a
record cleaning machine should be used.
Ask your dealer about Clearaudio´ s record cleaning machines.
• Always keep the stylus tip clean. When dirt is allowed to build up and
records are played with a dirty or clogged stylus, a buzzing noise may
be heard. Use a high quality cleaning brush or Clearaudio cleaning
uid to clean the stylus tip. Be extremely careful and always brush only
from back to front. When using a liquid e.g. from Clearaudio or other
organic cleaner, always take care not to spill any on the cartridge body.
Make sure the liquid only contacts the stylus tip or boron cantilever.
• Please note:
Never disconnect your tonearm cable from your pre-amplier while
your unit is still on. Please switch your pre-amplier o before starting
to disconnecting your tonearm connectors from the phono inputs of
your pre-amplier.
• Always use the original packaging when shipping the cartridge and
secure the stylus guard with a rubber band.
• If any service or repair to a Clearaudio product is necessary, please
contact your dealer / distributor.
We can advise you of your nearest service location.

Page 10 © clearaudio electronic GmbH
User manual / Bedienungsanleitung
I mportant - please note:
Do not try to remove the stylus assembly yourself.
Please contact your dealer / distributor.
Any damage caused by failure to follow the advice given in the Clearaudio
user manual will invalidate the product warranty.
Clearaudio will assume no liability for any such damage.
PLEASE RETAI N ALL ORI GI NAL PACKAGI NG.
You will need it if this unit has to be transported and/ or shipped.
Any further questions you may have about your product should be directed
to your dealer or distributor.
Clearaudio wish you a much enjoyment of your music!