clearviewaccessories.com.au
8
Fitting Instructions
Passenger side wires are: Green / Yellow, and Driver
side wires are: Red / Blue
Route RM (Right Middle) driver-side motor wire AND
R-LED connector under the vehicle dash and bring it
across to the driver-side footwell, then route both
through the rubber grommet in vehicle floor and
connect wire to the motor and LED connector on the
RM Bracket Assembly.
Route Passenger side motor wire and L-LED
connector through the rubber grommet in vehicle
floor and connect wire to motor and LED connector
on the LM Bracket Assembly.
Helpful tip when removing the rubber grommets, you
may either cut a single hole or a cross/+ pattern in
each grommet, sized to allow the plug on the wiring
looms to pass through.
Remember to place grommets back into floor panel of
vehicle and feed end of the Wiring Looms with small
plug through the hole in the grommet.
2.2 Connect motor wires to corresponding connectors on
motor wire harness.
NB: Holes for routing can be found under floor
carpet/vinyl depending on vehicle variant.
Connect the positive (red) wire from Step 1.2 to the
corresponding connector found on the motor wire harness.
2.3 Connect the negative (black) wire from the motor wire
harness to an earth/ground point on the passenger side of the
chassis, near where you would mount the ECU.
Connect the Motor Wire harness (small white
power plug) and Sensor Wire harness (large white
plug) to ECU.
Once connectors are plugged in, leave ECU and
wiring set in Left-Hand floor area, and tidy up at
the end to ensure enough slack of wiring can be
fed throughout the vehicle.
2.1 Layout ECU and Wire Harness set in Passenger
footwell area.
Step 2 Installation of control unit and wiring
Passenger (left) side
motor wiring
Passenger (right)
side motor wiring
Connector for RM motor
Connector for LED
