Coaster 460071 User manual

REVISION 1: 10/08/2012
REVISION 0: 05/14/2012
PAGE 1 OF 6
460071(B1-B3)
TWIN/TWIN BUNK BED
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
REVISION 2 : 11/06/2013
REVISION 3 : 01/21/2016

ARIGHT UPPER BED
END 1PC GLOWER SIDE RAIL 2PCS
BLEFT UPPER BED END 1PC HGUARD SUPPORT 2PCS
CRIGHT LOWER BED
END 1PC I
ROLL SLAT
(13PCS) 2SETS
DLEFT LOWER BED
END 1PC JRIGHT LADDER STILE 1PC
EUPPER GUARD RAIL 4PCS KLEFT LADDER STILE 1PC
FUPPER SIDE RAIL 2PCS LLADDER STEP 6PCS
1LONG BOLT 24PCS 6SHORT BOLT 6PCS
2BARREL NUT 24PCS 7SCREW 12PCS
3WOOD DOWEL 48PCS 8METAL DOWEL 4PCS
4MEDIUM BOLT 6PCS 9ALLEN WRENCH 1PC
5ALLEN CAP SCREW 12PCS
ITEM :
460071 (B1-B3)
HARDWARE INDENTIFICATION
PARTS IDENTIFICATION
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
PAGE 2 OF 6
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequencs as numbered to assure fast & easy assembly.
!
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact
the store immediately.
2. This product is for home use only and not intended for commercial establishment
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS.
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM
Z-B2 (BOX 2) HARDWARE PACK IS LOCATED IN 460071 (B2)

ITEM :
460071 (B1-B3)
ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP 3 STEP 4
www.coastercompany.com
PAGE 3 OF 6

ITEM :
460071 (B1-B3)
ASSEMBLY INSTRUCTIONS
STEP 5 STEP 6
STEP 7 STEP 8
www.coastercompany.com
PAGE 4 OF 6

www.coastercompany.com
PAGE 5 OF 6
SIZE OF MATTRESS
The length and width of the bunk mattress are as follow:
Length Width Thickness
Upper bunk 74" -
75" 37 1/2"-38 1/2" 6" Maximum
Lower bunk 74" - 75" 37 1/2”-38 1/2” 6" maximum
Ensure thickness of mattress does not exceed 6” and there must be at least 5” from mattress sleeping
surface to top edge of guardrail.
SAFETY WARNING
1. Follow the information on the warnings appearing on the upper bunk end structure and on the
carton. Do not remove the warning label from bed.
2. Always use the recommended size mattress or mattress support or both to help prevent the
likelihood of entrapment or falls.
3. Surface of mattress must be at least 5 in. (127 mm) below the upper edge of guardrails.
4. Do not allow children under 6 years of age to use the upper bunk.
5. Prohibit more than one person on upper bunk.
6. Periodically check and ensure that the guardrail, ladder, and other components are in their proper
position, free from damage, and that all connectors are tight.
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the ladder for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
10. Use of a night light may provide added safety precaution for a child using upper bunk.
11. Always use guardrails on both long sides of the upper bunk. If the bunk bed will be placed next
to the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and wall.
12. The use of water or sleep flotation mattress is prohibited.
13. Keep these instructions for future reference.
STRANGULATION HAZARD:
14. Never attach or hang items to any part of the bunk bed that are not designed for use with the bed
for example, but not limited to hooks, belts, and jump ropes.
REPLACEMENT PARTS:
Replacement parts, including additional guardrails may be obtained from any COASTER
Furniture Dealer.
ITEM :
460071 (B1-B3)
ASSEMBLY INSTRUCTIONS

1. When using beds as bunk beds, the ladder MUST be securely
attached to the upper bunk rail at all times.
2. When using the beds as two (2) separate floor-standing beds,
the ladder MUST be stored in a separate location where children
cannot use the ladder in any manner.
3. DO NOT use, nor permit children to use, the ladder in any
manner whatsoever, other than to access the top unit when
used as bunk beds, and only if the ladder is securely attached
to the top bunk rail, as set forth in the instructions.
4. Any misuse or unauthorized use of the ladder could result in
serious or fatal injury.
5. Failure to follow the above WARNING, and/or failure to follow
assembly instructions completely, will void any and all liability
of COASTER COMPANY OF AMERICA for damages and injury to
persons and property.
www.coastercompany.com | 877- COASTER (262-7838)
PAGE 6 OF 6
www.coastercompany.com
ITEM :
460071 (B1-B3)
ASSEMBLY INSTRUCTIONS