Coaster 704417 User manual

REVISION 0 : 02/09/2015
REVISION 1 : 03/03/2015
PAGE 1 OF 3
704417
END TABLE
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com

ASSEMBLY INSTRUCTIONS
A
B
1
2
3
4
5
6
7
www.coastercompany.com
C
TABLE LEG 4 PCS
SHELF
PAGE 2 OF 3
1 PC
BOLT 8PCS
LOCK WASHER
8PCS
HARDWARE IDENTIFICATION
PULL & SCREW 1PC
FLAT WASHER
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS.
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
ITEM :
704417
PARTS IDENTIFICATION
TABLE TOP WITH
DRAWER 1 PC
4PCSCAM BOLT
ALLEN WRENCH 1PC
CAM NUT 4PCS
8PCS
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
!
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment

ASSEMBLY INSTRUCTIONS
STEP 1
STEP 2
Screw in cam bolt ( 6 ) to table leg ( B )
2.1) Place table top (A) upside down on soft surface.
Align and fasten 1pc of table leg (B) to table top (A)
using bolt (2), lock washer (3) and flat washer (4)
and fully tighten with Allen wrench (1)
2.2) Align & fix shelf ( C ) to the cam bolt (6) of table
leg (B) , as per diagram shown.
2.3) Align and fasten another piece of table leg (B) to
table top (A) using bolt (2), lock washer (3) &
flat washer (4) and fully tighten with Allen wrench
(1), with shelf ( C) fixed to the cam bolt (6) of
table leg (B) simultaneously.
STEP 3
STEP 4
3.1) Align and fasten the rest of 2pcs of table leg (B) to
Align and fasten pull to drawer front using screw ( 7) and
table top (A) using bolt (2), lock washer (3) & flat
fully tighten with Phillips head screw driver
washer (4) and fully tighten with Allen wrench (1),
( NOT INCLUDED ).
with shelf ( C) fixed to the cam bolt (6) of table
leg (B) simultaneously
3.2) Fasten shelf (C ) to table leg (B) using cam nut (5)
and fully tighten with Allen wrench ( 1 )
www.coastercompany.com
ITEM :
704417
PAGE 3 OF 3