Coffee Queen CAFE ELITE User manual

Your retail dealer
EN
Rev. 110202
TECHNICAL MANUAL
CAFÉ ELITE

2.
1. Table of contents. Technical manual CAFÉ ELITE
1. Contents sid. 2
2. General 3
3. Overview User card 4
4. Warning message shown in display 5 - 6
5. Error code description 7
6. Circuit diagram 8
6. Circuit diagram UC and IO Pay card 9
7. Spare part list 10-11
8. Exploded view 12 - 16
9. Dimension sketch 17
10. Serviceintervals 18

3.
2. General. CAFÉ ELITE
Function description:
Café Elite has three nozzles, one for hot water and two for a choice of other drinks.
Café Elite has eight buttons, one of which is generally reserved for hot water only and
the others are programmable for dispensing a choice of other drinks.
Café Elite can be programmed to dispense a set volume or for continuous ow from
any dispenser nozzle or self-closing faucet.
First start up
Turn ON the main switch behind the door, display will show: “water level low”
“Press Enter”
Press the E button to conrm.
Energy Saving Mode:
Hold the stop button for 5 seconds. Display will show standby.
When the machine goes into standby mode, drinks cannot be dispensed and the
water temperature falls to the block ambient temperature.
To return to operation mode, press the stop button for 5 seconds.
Fact:
Height 735 mm
Width 310 mm
Depth 515 mm
Electrical connection. 1-phase 230V/2200W
Cold water connection: ½” Radius external thread
Ambient temperatures for correct operation +5ºC - +50ºC
Note: All options must be connected and installed by a qualied electrician.
4 Canisters
Canister: Width Depth Height volume/litre;
coffee 67 225 335 2,7
espresso 67 225 335 2,7
chocolate 67 225 335 2,7
topping 67 225 335 2,7
3 Canisters
Canister: Width Depth Height volume/litre;
coffee 137 225 335 2,7
chocolate 67 225 335 2,7
topping 67 225 335 2,7

4.
5. Overview of components, function buttons AC12
3. Overview of components, User Card CAFÉ ELITE
TECHNICAL SERVICE CARD.
Insert the user card, according to the illustration.
The display will show the Service Menu, Counters and you can now browse
forwards through the menu.
(TECHNICAL SERVICE CARD) Item number:
1602693.is used for adjusting drinks and
counters.
The user card is supplied by your dealer.
Service Menu
Counters
To use the machine again. Remove the card and keep it in a safe place.

5.
4. Warning message shown on display CAFÉ ELITE
Message on display:
Display shows
Hardware Error: Hardware error
Not available Drink cannot be selected as pot.
Heating Water Low temperature in the water tank, the machine
is heating up (blocked)
Please Wait...
Low Water Level Low water level in water tank.
Press Enter Key
Filling Water The machine is lling water.
Please wait
Select drink
Temperature Shows actual temp. in water tank
Strength + / - to increase concentrate
Jug Mode
Energy saving mode Machine is in Energy saving mode
Warning The temperature is low, it is still possible to dispense drink.
Low Temperature
Low Temperature The temperature is low, the machine is blocked.
Blocked
Empty Drip Tray The drip tray is full of water
Overcurrent Overcurrent

6.
Message on display:
Display shows
Error: The water has not reached the correct level in the water tank.
Water Supply Check the water tap, restart the machine.
Error: Check the level sensor, cable failure, level pins connected incorrect
Water level pins
Place Cup If the cup sensor has been activated, this is
shown if no cup has been placed on the drip tray.
Bev. Disabled The drink has been disabled
Please wait Shows when drink dispens
Door open
Error: Tempsensor damaged, faults in cables
Temp.sensor
Error: Solid state defect, heater defect. Output I/0 card is defect.
Check Heater
4. Warning message shown on display CAFÉ ELITE

Felkodsbeskrivning:
Error code description:
Overcurrent
Group 1:2 = Other components (Fan, Valves, Relays Etc..) (1,5A limit)
Group 1:3 = Mixer 1 (3,5A limit)
Group 1:5 = Mixer 2 (3,5A limit)
Message is shown if one of the software fuses have been trigged. Caused by a component
using too much current (A). You can run each component in the “Hardware Test” menu and
the message will show when you turn on the component that is using too much current.
ERROR: Water Supply
Message will show if the inlet valve has been open for more than 3 minutes and the
machine still have not acquired correct water level
Action: Check that the water to the machine is turned on, Check the levelsensor, test
function of the inlet valve in “Hardware Test”
ERROR: Tempsensor
Message will show if the NTC sensor is broken or is out of range of its resistance curve,
also if cables have loosened from its connectors.
Action: Replace NTC sensor, check cable connection on the NTC and PCB board.
ERROR: Levelpins
Message will show if the cables to the water level high & low have been connected to the
wrong levelpin.
Action: Swap cables to the levelsensor
ERROR: Check Heater
Message will show if the machine have not reached working temperature within
14 minutes from startup.
Action: Check Overheating protection, cables to the element, solid state relay, signal from
IO-board to solid state when you know the machine should heat, you can also force the
element to run in “Hardware Test”.
7.
5. Error code description. CAFÉ ELITE

8.
6. Circuit diagram. CAFÉ ELITE

9.
6. Circuit diagram. UC Pay

7. Spare part list. CAFÉ ELITE
Pos. Amount/unitArticle . no. Description
Valid for page 12 Door
1 1 1202551 Key switch
2 1 1665009 Left Overlay
3 1 1665002 Middle Printing Film
4 1 1665001 Membrane Switch
5 1 1604112 Display Board complete
6 1 180115 guide pin, Door
7 1 1602697 Card Reader
8 1 1605401 Grommet
9 1 260067-02 Spill Grid
10 1 1264007 Drip Tray Cafe Elite Black
Valid for page 13 Machine 1
1 1 120250 Key Lock
2 1 160841 Microswitch Instant
3 1 1206123 Non Return Valve complete
4 1 1604111 Main PCB
5 4 1205626 Canister W67 H350
6 1 1505076 Rubber Plug,10mm
7 2 120465 Rubber TPG 20.5
8 1 NA 01 Air Flow Pipe
9 1 160536 Rubber Trp 30.0 Shore45
10 1 1602414 Terminal Block for 4mm” Wire
11 1 1031652 Power Supply 150W
12 1 1604203 Solid State 25A
13 1 1206581 Seal Solid State
14 2 1604836 Hose Adapter for Mixing System
15 1 160801 Rocket switch single orange
16 1 120498 Bulkhead Adaptor
17 1 1205500 Spring Level Sensor
Valid for page 14 Machine 2
1 1 1561015 Over Flow Pipe
2 3 1206289 Outlet Valve Deltrol 24VDC
3 4 1604612 Motor gear 145rpm
4 4 1604614 Drive Shaft 16mm
5 1 1604351 Fuse Assembly
- 1 1604381 Fuse 4 Amp (slow 5x20)
6 1 1604173 Fan Connection Complete Black
7 1 1505042 Inlet hose with connect
8 1 160565 Power Cord European
9 1 160570 Power Socket
10 1 220220 High limit Switch
11 1 260141 Water tank 5L Assy deep draw
12 1 160841 Microswitch Instant
13 1 1403401 Inlet Valve Plug with Silicon Seal White
14 1 1604171 Fan 24VDC
15 1 1206371 Single Valve 2.5L 24VDC
10.