Coleman TIOGA 9273B128 User manual

Connect Frame to Tent
–Insert one end of main tent pole end
onto pin of pin & ring system, at tent
corner. (illus. 4)
–Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole.
–Repeat for second and third poles.
TIOGA™12’x8’
1Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with doors
facing desired direction. (illus. 1)
–Unzip doors.
–Stake down tent corners only, using the
rings at the end of the stake loops.
Keep the floor taut. (illus. 2)
–Assemble Frame Poles by
interlocking shock-corded poles.
This will make three long poles.
–Insert the poles diagonally into three
Pole Sleeves. (illus. 1)
2
WhenYou Are Ready To Set Up
Your Tent
–Select a level campsite clear of rocks,
branches and other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
do not position the door of tent into
the wind.
–See owners manual for more tips.
Rainfly
Pole Rainfly Part No. 9273B123
Main Tent
Poles
POLE ASSEMBLY PARTS
Insert poles
through
three pole
sleeves
Instructions apply to Part Number 9273B128
illus. 1
Part No. 9273-121
Part No. 9273-122
Tent frame
set-up
illus. 3
illus. 2 Tent stake
through ring
illus.4
Insert pole end onto
pin & ring

4Attach Rainfly
–Assemble rainfly pole by
interlocking shock-corded pole.
–Insert rainfly pole into reinforced
pockets located at the center edges
of the underside of rainfly.
(illus. 5), (illus. 6)
–Tie underside of rainfly to the rainfly
pole with frame ties. (illus. 5)
–Drape rainfly over tent frame, pole
side down. Rainfly pole should
point out over front and back side
of tent.
–Connect the six elastic loops with
“S” hooks, (found at the rainfly
corners) to the four rings.
located at the end of the stake loops
at the corners of the tent.
–Secure rainfly with frame ties
located on underside of rainfly. (illus. 7)
–Stake out tent with two side
guylines. (illus. 7)
illus. 6 Insert Rainfly
Pole piece into
pocket on underside
of Rainfly
illus. 7 Completed tent with Rainfly.
Note where Rainfly Pole pockets ,
“D” rings, and under ties are located
illus. 5
Underside
of Rainfly
ties onto
frame poles
“S” Hooks attach “D”
Rings at the corners
Attach and stake out Guy
lInes. One each side.
Rainfly
pockets
Rainfly Pocket
Frame
Ties
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
PRINTED IN CHINA Rev. 11/03
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be mini-
mized by removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Never store tent, even for a short period of time, without drying it thorough-
ly and brushing off caked dirt.Do not pack stakes or poles inside your tent.
Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. We recommend seam
sealing your tent prior to camping. Seam sealer may be purchased through
your local retailer or at your local sporting goods store.
• Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
• See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROMTHISTENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous contact with
any flame source.The application of any foreign substance to the tent fabric
may render the flame-resistant properties ineffective.