Commell CMB-67K-02 User manual

1
CMB-67K-02
Mini Barebone system
Intel High Performance Platform
User’s Manual
Installation Guide
Edition 1.0
2014/06/09

CMB-67K-02 Installation Guide
2
Document Content:
zPacking List
zProduct Specification
zHardware Installation
Packing List:
CMB-67K-02 Chassis x1
(Including LV-67K Motherboard)
DSPD-120-19 120W 19V AC-DC Adapter x 1
Power Cord x 1
CPU Cooler x 1
13-pin to 7-pin SATA Cable x1
SATA Cable 50 cm x1
ATX POWER output 20P to 4P*1 + SATA15P*1
20-pin DVI cable x1
DC JACK CABLE 26cm x1
CD Driver x1 (Including User’s Manual)
Hanging holders x2
CMB-67K-02

CMB-67K-02 Installation Guide
3
Hardware Installation:
Motherboard placement

CMB-67K-02 Installation Guide
4
Jumper Location & Reference

CMB-67K-02 Installation Guide
5
I/O panel:
Front:
CD-ROM
Reset ButtonHD LED
Power LED Power Button
USB 2.0USB 2.0
Mic / Ear-Phone

CMB-67K-02 Installation Guide
6
Rear:
Power input : DSPD-120-19 120W 19V AC-DC Adapter Input.
SPDIF
USB 3.0
COM Port
VGA
DVI DC-IN
Antenna Port
Mouse
Keyboard
Line-In
Line-Out
Mic
LAN

CMB-67K-02 Installation Guide
7
Chassis Setup procedure:
1. Turn the screws and refer the picture A and B and C.
(A)
(B)

CMB-67K-02 Installation Guide
8
(C)

CMB-67K-02 Installation Guide
9
2. Push the Chassis shield towards the back then open it.
2
1

CMB-67K-02 Installation Guide
10
3. Turn the screws.

CMB-67K-02 Installation Guide
11
4. Push the front panel towards the front then take the CD-ROM holder
off.

CMB-67K-02 Installation Guide
12
5. Turn the CPU cooler screws and then refer the motherboard manual
page.16 to install the CPU.
(After installing CPU, please turn the CPU FAN screws to tighten.)

CMB-67K-02 Installation Guide
13

CMB-67K-02 Installation Guide
14
6. Open the Dimm holder then check the pin number to match the socket
side well before installing memory module. (It has two slots to choice,
or use both of them.)

CMB-67K-02 Installation Guide
15
7. Press down the memory module then check dimm holder hook well.

CMB-67K-02 Installation Guide
16
8. After install HD driver, Turn the CD-ROM holder and front panel screw well
refer picture.

CMB-67K-02 Installation Guide
17
9. Check the CD-ROM driver SATA input direction.
(If you don’t install CD-ROM drive please direct to step.14)
10. Check the CD-ROM driver and SATA cable connects well, then connect
the ATX output (4-pin).

CMB-67K-02 Installation Guide
18
11. After install HD driver, Turn the CD-ROM holder and front panel screw
well. Refer picture A and B.
(A).
(B).

CMB-67K-02 Installation Guide
19
12. Turn the CD-ROM driver screws and SATA cable connects well.

CMB-67K-02 Installation Guide
20
13. Find out the HD holder to install HD driver, it is under backside of the
CD-ROM holder.