CommScope CMAX-OMF7-43-UWI53 User manual

M0149AUB_InstInstr_CM AX-OMF7-43-UWi53
Technical Support:
http://w ww .com m scope.com /w is u pp ort
INSTALLATION INSTRUCTION FOR
CMAX-OMF7-43-UWI53
Method 1
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna.
3) Feed these two pigtails of this antenna through the hole in the
ceiling tile.
4) Re-installthe retaining nut so that it is close-fitting to the ceiling tile.
Method 2

M0149AUB_InstInstr_CM AX-OMF7-43-UWi53
Technical Support:
http://w ww .com m scope.com /w is u pp ort
Installation Steps
1) Position and drill the screw holes of the specified size (one ≥ M35
cylindrical hole, four M6 screw holes).
2) Put plastic expansion pins in the M6 holes first.
3) Feed these two pigtails of this antenna through the hole in the
ceiling tile.
4) Use M4*25 self-tapping screws to lock the antenna to the ceiling
according to the corresponding hole position.
Note: Cable min. bending radius: 40mm
© Copyr ig ht 2020 Com m Scope, Inc.
All r ig hts r eser ved.
All information contained in this manual has been revised thoroug hly. Yet C ommScope accepts no liability for any om issions or
faults.
CommScope reser ves the right to chang e all har dware and software characteristics without notice.
Names of products menti oned her ein are used for identification purposes only and may be trademarks and / or reg istered
tr adem ar ks of their respective companies.
No parts of this publication may be reproduced, stor ed in a retrieval system , transm itted in any for m or by any m eans,
electr onical, mechanical photocopying , recording or other wise, without prior written permission of the publisher .
CommScope, 04-May-2020