CommScope CMAX-DMF-43-UW-i53 User manual

Installation Instruction for CMAX Antennas
Page 1 M0149ASB_Installation_CMAX-DMF-43-UW-i53_Antennas
Installation Guide for
CMAX-DMF-43-UW-i53 Antenna
Note: Please read the complete description before starting the installation. Make sure
that connectors are properly sealed against water if no cables are connected to
them after installation.
1.Assembly
Fit these seven parts above together and fasten them with screws M6, nuts M6, spring
washers, and washers.
Screws
Spring washer
M6 Nuts
Washer

Installation Instruction for CMAX Antennas
Page 2 M0149ASB_Installation_CMAX-DMF-43-UW-i53_Antennas
2.Wall Mounting
1. Use this pedestal piece as a drill jig to mark 4 holes onto the wall as shown in the
drawing above.
2. Drill 4 holes into the wall and insert 4 expansion bolts into holes.
3. Install the mounting kits to the expansion bolts and tighten the M6 nuts and flat
washers.
4. Attach the antenna to the mounting kits and then tighten the M4 nuts, spring washers
and flat washers...

Installation Instruction for CMAX Antennas
Page 3 M0149ASB_Installation_CMAX-DMF-43-UW-i53_Antennas
3.Pole Mounting (28~60 mm pole diameter)
28~60 mm

Installation Instruction for CMAX Antennas
Page 4 M0149ASB_Installation_CMAX-DMF-43-UW-i53_Antennas
4.Antenna Mounting
4.1. Antenna Mounting
4.2. Azimuth Angle
1. Loosen the
fixing screw. (Do NOT
unscrew it completely.)
2. Adjust your desired angle. The
complete antenna pedestal can be
swiveled to the left- / right-hand side
by up to 60°.
3. Tighten the f ixing screw.
M4 nut
Washer
Spring Washer

Installation Instruction for CMAX Antennas
Page 5
Technical Support:
http://www.commscope.com/wisupport
M0149ASB_Installation_CMAX
-
DMF-43-UW-i53_Antennas
4.3. Elevation Angle
1. Loosen the f ixing screw. (Do
NOT unscrew it completely.)
2. Adjust your desired angle. The
complete antenna pedestal can
be swiveled to the top / bottomby
up to 40°.
3. Fasten the fixing screw.
Note: Cable min. bending radius: 40mm
List of Changes
Version
Changes
Release Date
M0149ASA
First release
04-September-2019
M0149ASB
Bending radius addedin chapter4.3
04-May-2020
© Copyright 2020 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability forany omissions or faults.
CommScope reserves the right to change allhardware and software characteristics without notice.
Names of products mentioned herein are used foridentification purposes only and may be trademarks and / orregistered trademarks of
their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means, electronical,
mechanical photocopying, recording or otherwise, without prior written permission of the publisher.
CommScope, 04-May-2020