CommScope CMAX-OUS1-UW-I53 User manual

M0153A8A_InstI nstr _CM A X-OUS1-UWxx-i53
Technical Support:
http://w ww .com mscope.com /wi su pp or t
INSTALLATION INSTRUCTION FOR
CMAX-OUS1-UW-I53 AND CMAX-OUS1-UW43-I53
Method 1:
Installation Steps
1) Cut a h ole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenn a.
3) Feed these two pigtails ofthis antennathrough theholein theceilingtile.
4) Re-install theretaining nutso thatit is close-fitting to the ceiling tile.
Method 2:

M0153A8A_InstI nstr _CM A X-OUS1-UWxx-i53
Technical Support:
http://w ww .com mscope.com /wi su pp or
Installation Steps
1) Position and drill threescrew holes ofspecified size.
2) Put plastic expansion pinsin theholes first.
3) Feed these two pigtails of this antenna thro ugh the hole in th e ceiling tile.
4) Use 4*25 self-tapping screws to lo ck the antenn a to the ceiling according to the
correspondingholeposition.
5) Then cover the screw hole cover (available, but not required).
Note:
Cable min.bending radius:40mm
© Copyr ig ht 2020 Com m Scope, Inc.
All r ig hts r eser ved.
All inform ation contained in this manual has been revised thoroug hly. Yet C om m Scope accepts no l iabil ity for any om issions or
faults.
Com m Scope reser ves the right to chang e all hardware and softwar e char acteristics without notice.
Nam es of products mentioned herein ar e used for identification purposes only and may be tradem ar ks and / or reg ister ed
trademarks of their respective companies.
No par ts of this publication may be reproduced, stored in a retrieval system , transm itted in any form or by any means, electr oni cal,
mechanical photocopying , recording or otherwise, without pr ior written permission of the publisher.
Com m Scope, 18-May-2020