CommScope CPPR-QF-F-1U-E User manual

Instruction manual for Foldable UCP Patch Panel
5. INSTALLATION OF FIBER OPTIC MODULES
5.1 Installation of MPO cassettes
5.1.1 12 fiber MPO cable
- Attach the white cable clips and position the cable tie.
- Install midi fan-out
- First clean MPO connector end face in the rear of the cassette, then insert the Quick-Fit
MPO cassette into the UCP panel. Next clean the MPO connector end face from the incoming
cable, dressing it into the cable clips at the rear of the panel (maintaining a minimum bend
radius of 50mm at all times). Finally, connect the incoming MPO cable to the MPO cassette.
5.1.2 24 fiber MPO cable
- Attach the white cable clips, position the
cable tie and install the midi fan-out.
- Same as 5.1.1
Note: Unused ports can be covered by blank Quick-Fit modules.
1.SCOPE
1.1 Purpose
The purpose of this specification is to provide specific instructions for assemble instruction
for retention packs.
1427592-1
Item Description Unit Qyt
1
2
3
5
6
4
PCS
PCS
PCS
PCS
PCS
PCS
1
1
1
4
4
4
Panel with Arms
Rear Bracket
Grounding Nuts
M6 Screw /nut/gasket
Fiber Bracket
Hook and Loop Tie
3.ASSEMBLY REQUIREMENTS
3.1 Rotate the arm 3.2 Fix the rear bracket with panel
3.3 Install the grounding bolt at the back of
the panel
3.4 Fix the panel in cabinet with screws
1427544-1
Part number：1427544-1 – Flat 1427592-1 – Angled
2.FOLDABLE UCP PATCH PANEL KITS CONTENTS
Instruction Manual
411-102033
2023 May Rev D
411-102033
Rev.D
To obtain information on CommScope
®
products,
contact your local CommScope
®
account
representative, PartnerPRO
™
Network Partner
or visit our website at www.commscope.com
©2023 CommScope, Inc.
All Rights Reserved

4.INSTALLATION OF COPPER MODULES
4.1 Installation of MRJ21 cassettes
-Insert the MRJ21 & MRJ21 XG cassette -Connect the MRJ21 connector
-Secure the cable with hook-and-loop fasteners
4.2 Installation of pre-terminated cable bundle
- Fee the pre-terminated bundle through the cut Out in the panel
- Insert all the connectors into the Quick-Fit module
- Insert the Quick-Fit module into the panel, and Secure the cable bundle
with hook-and-loop fasteners
4.3 Installation of Sigma-Link Modules
- Insert the Sigma-Link front cover
- Insert the Sigma-Link assembly into the opening of the Patch panel. Check TOP
marking on the module and front cover. An audible click indicates the cassette is in position.
- Secure the cable with hook-and-loop fasteners
- To remove the assembly: push the side-taps outward whilst at the same time pulling
the cable bundle towards the rear of the panel.
411-102033
Rev DRev D
411-102033
2023 May Rev D