CommScope NETCONNECT 1479542-1 User manual

Figure 1
This instruction sheet provides installation procedures
for NETCONNECT Undercarpet Multimedia Dual
Data Kit 1479542–1.
To obtain information on NETCONNECT products,
call Product Information at the number at the bottom
of this page, or visit the NETCONNECT website at
Reason for revision is given in Section 3, REVISION
SUMMARY.
The NETCONNECT Undercarpet Multimedia Dual
Data Kit consists of a cover, a baseplate, and four
oval–head screws to use when mounting the cover.
Foam tape is attacked to the underside of the
baseplate. This kit can be used for undercarpet
applications and underfloor duct systems.
The baseplate can be mounted using one of two
methods (mounting hardware/foam tape).
If using mounting hardware (customer supplied),
proceed as follows:
1. Center baseplate on reference line and mark
hole locations.
2. Drill holes to accept mounting hardware.
3. Vacuum debris. Insert hardware.
Figure 2
If using foam tape, proceed as follows:
1. Vacuum debris.
2. Peel back the release paper on the tape.
3. Position baseplate in desired location. Press
firmly to secure.
Figure 3
NETCONNECT® Undercarpet
Multimedia Dual Data
Kit 1479542-1
Instruction Sheet
408-8843
FEB 2017 REV B
To obtain information CommScope® products, visit our website at
http://www.commscope.com/SupportCenter/TechnicalSupport.aspx
©2017 CommScope, Inc.
All Rights Reserved
This product is covered by one or more U.S.
patents or their foreign equivalents. For patents, see
www.commscope.com/ProductPatent/ProducePatent.aspx

Figure 4
Proceed as follows:
1. After wiring is complete, snap the single port
outlet into the bottom of the cover. See Figure 5.
Figure 5
2. Attach the outlet to the cover by inserting two
No. 2 screws into two diagonal posts on the
housing. See Figure 6.
Figure 6
3. Align faceplate and press on from the FRONT of
the housing. See Figure 7.
Figure 7
B

Figure 8
Proceed as follows:
1. After wiring is complete for jack applications,
snap the modular jack into the appropriate opening
in the baseplate. Refer to Figure 9.
Figure 9
2. Terminate SVGA connector according to color
code on connecting blocks. Assemble connector to
baseplate using hex standoff screws. See
Figure 10.
Figure 10
1. Align the screw holes in the cover with the posts
on the baseplate.
2. Secure by inserting the oval–head screws.
3. Tighten screws.
Figure 11
Updated document to corporate requirements
Added NOTE to Paragraph 4.2
B
Rebranded to CommScope