COMPANION AQUAHEAT LiTHIUM User manual


2
IMPORTANT
This appliance is designed to be used with a source
water temperature of 20˚C or below.
The maximum temperature lift from the appliance is
30˚C from the source water temperature.
For safety the appliance is designed to shut off the
burner when the water temperature exceeds 50˚C
+/- 2˚C (average).
The average run time for the appliance from a fully
charged battery is 45 to 50 mins before it will require
recharging.
The appliance can be operated whilst connected to AC or
DC. The battery will accept charge if it is less than 12V
whilst operating.
GENERAL WARNINGS
This appliance shall only be used with the regulator
supplied with the appliance. This appliance shall only be
used with a ULPG rellable cylinder certied to Standard
AS 2469 that has a 3/8” LH BSP inlet tting, or a non-
rellable 468g disposable Propane cartridge certied to
DOT-39, UN1075.
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER
TYPES OF GAS CONTAINERS.
This appliance is to be stored in a dry and well ventilated
location free from direct sunlight. Do not store when still
connected to the cylinder. Make sure that the cylinder is
disconnected and is stored in a well ventilated area, free
from direct sunlight, heat and ignition sources. If being
stored indoors ensure that the location complies with the
standard AS/NZS1596.
This appliance must only be serviced by an authorised
service agent, return to your place of purchase for
service and repair or contact Customer Service
1300 555 197.
Ensure any transit protection is removed before the
appliance is used.
When using Rellable Gas Cylinder:
If there is a leak on your appliance (smell of gas),
immediately attempt to turn off the cylinder valve.
Remove the appliance to a well ventilated location away
from any ignition source. Check for leaks using soapy
water. Do not try to detect leaks using a ame.
When using Disposable Cartridge:
If there is a leak from your appliance (smell of gas) and
you cannot stop the gas ow, remove the appliance to a
well-ventilated location away from any ignition source.
Check for leaks using soapy water. Do not try to detect
leaks using a ame.
IMPORTANT: Read these instructions for use carefully. Familiarise yourself with the appliance before
connecting it to its gas container. Keep these instructions for future reference.
THIS APPLIANCE IS NOT INTENDED FOR THE SUPPLY OF DRINKING WATER
This appliance is intended for the supply of heated water for the purpose of washing and cleaning
only. Check and confirm safe water temperature before using this appliance. Water from this
appliance may be very hot.


4
CHECKING FOR GAS LEAKS
Check that all connections are tight and that the gas
connection has been leak tested before you turn the
appliance on.
Never check for leaks with a ame or pilot light.
Using soapy water coat all connections, if bubbles
appear retighten the cartridge before re-testing.
This appliance must only be serviced by an authorised
person.
Inspect the appliance regularly for signs of wear, leaks
or incorrect operation. If symptoms such as aring of
the burners, issues with lighting, damages connections
or leaks from seals or gas controls are identied do not
attempt to repair, contact Customer Service on
1300 555 197.
To check if gas remains in the cartridge, disconnect
from the appliance and hold the cartridge in a vertical
position then shake from side to side. If there is a sound
or a feel of liquid movement inside the cartridge, the
cartridge contains gas.
When changing gas cartridge ensure this is conducted
outside in a well ventilated location free from people,
animals and ignition sources such as naked ames, pilot
lights and electrical equipment with heaters or elements.
Check the seals are in place & gas hose is tight before
checking for leaks (if using gas hose to cylinder).
Check that the seals between the appliance and the
gas cartridge are in place and in good condition before
connecting the gas container.
Do not use the appliance if it has damaged or worn
seals.
Do not use this appliance if it is leaking, damaged or
does not operate properly.
IMPORTANT
This appliance is designed to be used with a source
water temperature of 20˚C or below, if the temperature
of the outlet water exceeds 50˚C +/- 2˚C the burners
will shut off and will only relight once the outlet water
temperature falls below 45˚C.
This appliance is designed to raise the outlet water
temperature by a maximum (average) of 25˚C to 30˚C
above the source water temperature and can be adjusted
by the gas control. In the event that the temperature lift
is insufcient, simply run water through the appliance
once returning the heated water to the source water
reservoir. Run again through the appliance until the
desired temperature is reached.
During operation ensure that all air inlets and exhausts
are kept free from obstructions and closure.
SAFETY FEATURES
This appliance is equipped with the following safety
features:
Over temperature sensor
The appliance will not allow the burner to remain in
operation once the outlet water temperature reaches 50˚C
+/- 2˚C, the burner will automatically relight once the outlet
temperature falls below 45˚C.
Water flow sensor
Water must be owing through the system to allow the
burner to ignite. In the case that the water supply is
restricted or ceases, ie. the ow switch on shower head is
in the off position, the burner will be extinguished and will
not relight until the water ow recommences.
Tilt switch
In the event that the appliance is moved during operation or
is being operated on an unstable or non-solid surface the
appliance will shut down and must be switched off until a
suitable surface is located.












Designed & Imported by:
Adventure Trading Australia Pty Ltd
71 Charles Ulm Place,
Eagle Farm, QLD 4009
AUSTRALIA
Made in China
WARRANTY - For details see www.companionleisure.com.au/warranty
WARRANTY
Companaion®is a registered trademark of
Adventure Trading Australia P/L warrants this product against defects for a period of three years from the
date of purchase. Adventure Trading Australia P/L will repair or replace the product, at its discretion, should
a warrantable defect arise within the warranty period. If the exact model is unavailable a model of equivalent
nature will be substituted at our discretion. This warranty excludes faults and failures caused by improper use
and abuse; fair wear and tear; incidental loss or damage; or failure to follow instructions regarding care and
maintenance. Products used for a commercial nature are not covered by this warranty against defects. A warranty
may be claimed by returning the product to its place of purchase, with a detailed proof-of-purchase clearly
showing the date and detail of the purchase.
You can contact Adventure Trading Australia P/L Customer Service by phone on 1300 555 197,
in writing: PO Box 1110, Eagle Farm QLD 4009. The benets under Adventure Trading Australia P/L warranty
against defects are in addition to other rights and remedies under law in relation to goods.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
This manual suits for next models
1
Table of contents
Other COMPANION Bathroom Fixture manuals
Popular Bathroom Fixture manuals by other brands

Fackelmann
Fackelmann 82952 Instructions for mounting and use

PAX
PAX Paulina installation guide

Athena BATHROOMS
Athena BATHROOMS Fleet Vanity installation instructions

Uberhaus
Uberhaus Vanity user manual

DianHydro
DianHydro EMOTION SERENITY 179-MSA Series user manual

Franke
Franke ACXX2004 Installation and operating instructions

CEA
CEA AQC06 manual

Dietsche
Dietsche BRAVAT P7075C-RUS quick start guide

Kohler
Kohler NEW MEMOIRS K-76563T installation instructions

Hans Grohe
Hans Grohe Talis C 14111 1 Series Installation instructions / warranty

Kohler
Kohler K-T10340 Homeowner's guide

Porcelanosa
Porcelanosa noken lounge 100063511 Installation and Maintenance