OWNERS MANUAL
3
OPERATING INSTRUCTIONS
• Use clean water, do not use direct from river
or lakes
• Do not operate shower without water at any time
• Ensure bucket is filled with sufficient water for
intended use
TECHNICAL DETAILS
1. Place pump in a bucket or connect to water container.
If using a bucket, ensure water pump is fully
submerged in water to prevent damage.
2. Insert plug into suitable 12V DC outlet
and push switch on.
3. Adjust flow of water as required using control on shower head.
When using the camp shower, stretch the hose vertically to
allow any air bubbles to escape, which may impede water flow.
IMPORTANT
Do not take the pump out of the bucket while in use
and ensure it is submerged in water before use.
SPECIFICATIONS
Part No.: PRI0012
Water Flow: 6L per minute*
Power Supply: 12V DC
Power Cord Length: 5m
Silicone Hose Length: 2m
Fuse: 5 amp
Max Draw: 3 amp*
*Average
IF WATER DOES NOT FLOW
1. Turn off pump
2. Lift pump from bucket and hold shower head
vertical to draw water from shower
3. Place pump in bucket and retry
IF PUMP DOES NOT RUN
1. Check sufficient 12V DC power is available
2. Check fuse in cigarette lighter fitting
TO CLEAN
To clean the outside of the camp shower, use
only a damp cloth and mild dishwashing liquid.
