CompuLab fitlet2 FC-USB User manual

fitlet2 FC-USB installation instructions
Package
Content
2x
retaining
Washer
2x 6mm
Phillips
screw
1x FC-
USB
1x side
panel
05.DEC.18
Plug the 3pin power cable to the
back of the FC-USB in the J1
port
1x 3pin
power
cable

Place the red module spacer in
the designated location then
place the M.2 storage
component side facing
downward to the thermal pad.
Then fasten using the 1x Phillips
screw
The red module spacer should
be supplied with the product's
packaging or already assembled
Place the retaining washers at
the designated location on the
cooling plate and seat the FC-
USB on-top of them. Then fasten
the 2x Phillips screws
The cooling plate should be
supplied with the product's
packaging or already
assembled.
Plug the 3pin power cable to the
J11 port

Assemble the cooling plate with
the components installed as a
whole unit to the M.2 connectors
Fasten the cooling plate in place
assembling the 3x Phillips
screws.
The 3x Philips screws supplied
with the product's packaging or
already assembled.
Stick the RTC battery in its place

Screw the 4x Phillips enclosure
screw half way, enough to hold
the bottom cover in-place but not
too tight
Complete by tightening the
Phillips enclosure screws all the
way down, while holding the side
panels
Bring both side panels in place,
and hold them
Before placing the bottom cover,
make sure the Kensington lock
mechanism is oriented to align
with the side panel that has the
Kensington lock hole