Cooper Lighting HALO DE641 User manual

313
TRACK LIGHTING Two Circuit
COOPER LIGHTING
HALO®
L994 45° Pendant Adapter
For installing pendant mounted Power-Trac on
sloped ceiling. For use with L992 and L993.
Finish: White (P), Black (MB)
L983 T-Bar Attachment Clip
Allows track to be attached to inverted tee
ceiling. Order as follows: 2 kits for 2’ Trac; 2
kits for 4’ Trac; 3 kits for 8’ Trac; and 4 kits for
12’ Trac.
L986 T-Bar Attachment Clip
For mounting track on suspended ceilings with
mini-grid (9/16" wide) system.
L949 Mini Joiner
To join two straight track sections end-to-end.
Not a feed point.
Finish: White (P), Black (MB)
L946 X Connector
To connect four track section into a cross
configuration. May be used for feed point.
Finish: White (P), Black (MB)
L945R Right T Connector
“T” connector for joining three trac sections
with right hand polarity. May be used as feed
point.
Finish: White (P), Black (MB)
L942 Flex Joiner
To connect two track sections at any angle up
to 90,° in either plane or wall to ceiling or
pitched ceiling applications.
Finish: White (P), Black (MB)
L992 Pendant Kit Assembly
To suspend track from ceiling. Order as
follows: 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3
kits for 8’ Trac; and 4 kits for 12’ Trac. Includes
one 18” threaded steel stem, canopy and
mounting hardware.
Finish: White (P), Black (MB)
L48 48” Steel Stem
For additional length of stem for L992. Can be
field cut and threaded.
DE641 Dead End
Replacement Dead Ends for Two Circuit Track
(6 included)
Finish: White (P), Black (MB)
L989 Conduit Continuation Kit
Includes one left and one right feed. To
continue
a run around obstructions with 1/2” trade size
surface conduit.
Finish: White (P), Black (MB)
L951 Wire Way Cover for
Pendant Assembly Kit
For track to be wired through stem (one for
each live end used). Shown with end feed and
pendant stem kit–order separately
Finish: White (P), Black (MB)
L947 Conduit Connector
A live end connector for use with surface
conduit. Designed to accept standard 1/2”
conduit fitting (not included). May be used for
feed point.
Finish: White (P), Black (MB)
L945L Left T Connector
“T” connector for joining three trac sections
with left hand polarity. May be used as feed
point.
Finish: White (P), Black (MB)
L943 Straight/L Connector
To connect two track sections end-to-end or at
a 90° angle. May be used as feed point.
Finish: White (P), Black (MB)
L929 Floating Canopy and
Connector
Can be connected anywhere along length of
Trac. Comes with canopy cover, connector,
dead-end and mounting hardware.
Finish: White (P), Black (MB)