Copeland Furniture Catalina Credenza User manual

Assembly Instructions for
Catalina Credenza
Please identify the
listed items before
installation.
Hardware included:
Shelf support pins (8) Components included:
Shelves (2)
Adjustable Shelf
This file cabinet has been fitted with an
anti-tip device so that it will not tip forward if
both filled drawers are opened at the same time or
when the top filled drawer is opened with the bottom
drawer closed and empty. Because of this device
only one drawer may be opened at a time.
File rods (8)
Shelf support pin
Tools required None
Step 1: Install the shelves
Open the doors. Insert shelf
support pins into the holes in the
case sides and carefully place the
shelf on them (Figure 1).
1
Figure 1.
Install the shelves

Tools required
Each door can be leveled by adjusting
two hinges. There are three screws on
each hinge and each can be adjusted
independently (Figure 2). The first
screw can adjust the door in the left and
right direction. The second screw can
adjust the door up and down. The third
screw can move the door in and out.
Please adjust your door accordingly.
Step 2: Level the door
Philips head screwdriver
Figure 2. Level the door
2
Safety Notification
Copeland Furniture is in compliance with ASTM’s volunteer Standard Safety Specification for Clothing
Storage Units (2014 revision) –commonly known as the furniture tip-over standard. It is strongly
recommended that you install the anti-tip stop included with your furniture to help prevent a potential top-
over of the furniture onto a small child.
For more information, please visit www.astm.org/Standards/F2057.htm.
Left & Right
Up & Down In & Out

If you have any questions or difficulties, please call us at the number below between the hours of 8:00 am and 4:30 pm eastern time.
156 Industrial Drive, Bradford, VT 05033 Tel: [phone] Fax: [phone] www.copelandfurniture.com
Care Instructions
To care for and preserve the finish on your new Copeland Furniture piece, please keep the following
recommendations in mind.
While our furniture has been finished with a durable top coat, the surface may be sensitive to
dents and abrasions during the first 30 days in your home.
Treat the surface finish gently so it does not dent or chip. Tape or stickers should not be put on
the finish.
For general care use a soft cloth to dust the furniture.
Use damp cloth with a mild soap to clean-up spills or dirt. Dry the surface thoroughly.
Please do not use any polishes, waxes or solvents to clean the surface of the furniture. This
holds true for new Copeland Furniture pieces as well as items you may already have in your
home.
Please do not place any candles directly on the surface of your furniture. The perfumes and
dyes in the candles may penetrate the finish.
Beds must be disassembled before moving to avoid damage. Never attempt to move the bed
while it is assembled.