Core Health & Fitness STAR TRAC 8-RB User manual

Page 1
620-8368 Rev. D
Headphone Jack Install
Required Tools:
• #2 Phillips Screwdriver
8-G
1. Apply the 3.5mm cover decal to the front of the
8-G console USB/HDMI front plate, covering the
hole for the 3.5mm headphone cable.
NOTE: The 8-G uses the headphone jack installed in
the hotbar (see Step 2) NOT in the console itself.
2. Use a #2 phillips screwdriver to remove the screw
securing the headphone jack cover, then remove
the cover. Install the headphone jack PCB onto
the headphone jack PCB mount, then install the
mount into the hotbar.
3. Finally, install the mount using the screw re-
moved in Step 2 to secure the headphone jack
cover.
8-RB / 8-UB / 8-CT / 8-RDE / 8-VS / 8-FC
1. Use a phillips screwdriver to remove the two (2)
#8-18, 3/4” screws securing the USB/HDMI front
plate, then remove the front plate. Install the
headphone jack PCB onto the front plate where
indicated then reinstall the front plate. Finally,
apply the face plate decal with the hole for the
3.5mm headphone jack.
2. Install the 90 degree end of the 3.5mm cable
(715-3834) into the 3.5mm headphone jack locat-
ed on the MYE TV controller PCB. Install the other
end of the 3.5mm cable into the headphone jack
PCB installed in Step 1

Page 2
620-8368 Rev. D
8-TRx / 10-TRx
Required Tools:
• #2 Phillips Screwdriver
• 3mm Allen Key
1. Use a #2 phillips screwdriver to remove the PCB
from the Gen 1 hotbar insert, then install it into
Gen 2 hotbar insert.
2. Use a 3mm allen key to remove the M4 x 16mm
socket head cap screw securing the headphone
cap into the hotbar, then remove the headphone
cap.
3. Install the Gen 2 hotbar insert built in Step 1 into
the hotbar, then use a 3mm allen key to secure
the insert using the same socket head cap screw
from Step 2.