
SYNTHETIC LEATHER CARE
• For general cleaning, wipe down the leather with a damp cloth, then a dry cloth.
• Avoid excessive brushing or rubbing while cleaning the leather.
• To remove stains, use a damp cloth with a 3-5% neutral detergent, then wipe with a dry cloth.
• Do not use benzene, thinner, alcohol, or any other solvent or abrasive cleansing agent on the leather.
PLASTIC CARE
• Use a damp cloth with a 3-5% neutral detergent to clean the plasc components of the massage chair.
• Dry with a cloth or allow to air dry.
TABLET REMOTE CONTROL CARE
• Do not use a damp cloth to clean the remote control. Use only a clean dry cloth.
• Do not use benzene, thinner, alcohol, or any other solvent or abrasive cleansing agent on the remote
control.
• Turn the main power switch off and disconnect the power plug from the electrical outlet before cleaning
the chair to reduce the risk of electric shock.
• Never use wet hands to connect or disconnect the power plug from the electrical outlet.
• Do not use a damp cloth to clean the power cord.
CLEANING INSTRUCTIONS
MOVING THE MASSAGE CHAIR
The massage chair can be moved by raising the front of the chair and lng back on the wheels.
• Unplug and remove the power cord and remote control before moving the chair.
• Use cauon when handling the armrests and legrest ooman to avoid damage.
• Use cauon when rolling the chair across a le or wood floor.
• To prevent the floor from being scratched, it is recommended that you place a towel or
blanket under the wheels or li the chair using at least four people.
• The chair should be placed on a flat level surface and away from damp rooms (i.e. bathrooms)
and open flames (e.g. stove, fireplace).
• It is recommended that you place a so mat underneath the chair to protect your floors.
The massage chair is connected to the
power supply but the remote control is
not working.
There are sounds inside the massage chair
when it is being used.
The massage chair becomes louder when
it is being used.
The massage chair suddenly stops working
when it is being used.
The massage chair will not extend, recline or
return to its upright posion.
If you connue to have problems, turn off the main power switch, unplug the power cord from the
electrical outlet and contact your retailer’s service department or CORENINE at corenineusa.com.
The air pump, motor and mechanical parts of your massage chair
will make various beeping & humming sounds.
The power switch may not be turned on.
The power cord plug may not be properly connected to a working
electrical outlet.
A fuse may have burned out.
The “On/Off” buon on the remote control may not be turned on.
The power cord may be damaged.
The massage me may be complete.
Your electrical power may have stopped working. Check to make sure your power is connected.
The massage chair may be overloaded from extended use.
There may be obstacles in the way.
The massage chair may be overloaded from extended use.
Replace the fuse.
Turn on the power switch.
Reconnect the power cord plug to a working
electrical outlet.
Turn the “On/Off” buon on the remote control
to the “On” posion.
If damaged, contact your retailer’s service
department for a new power cord.
Choose a new massage mode or turn off
your massage chair.
This is normal.
Turn off the massage chair for at least 30 minutes.
Turn off the massage chair for at least 30 minutes.
Remove the obstacles.
TROUBLESHOOTING
PROBLEM TROUBLESHOOTINGPOSSIBLE REASON FOR PROBLEM
!WARNING
10 11