
www.costway.com
-This product is suitable for indoor and outdoor use. Do not use this heater in the
immediate surroundings of a bath, shower or swimming pool.
-This product must not be left outdoors exposed to the elements for long periods of
time.
-Do not touch the plug with wet or damp hands.
-Do not run the power cable under carpeting. Do not cover the power cable with rugs,
runner, or similar coverings. Arrange the power cable away from foot traffic and
where it will not be tripped over.
-Do not wind the power cable around the unit.
-Do not insert or allow foreign objects to enter any ventilation or opening on the
heater, as this may result in electric shock, fire, or damage to the heater.
-To prevent a possible fire, do not block the air vents.
-A heater has hot and arcing or sparking parts inside. Do not use in areas where
petrol, paint, explosive and/or flammable liquids are used or stored. Keep unit away
from heated surfaces and open flames.
-Where possible, avoid the use of an extension cable as this may overheat and
cause a fire. However, if you have to use an extension cable, ensure it is suitable for
the purpose, has been tested for outdoor use and preferably has an RCD device
fitted or attached.
-Always ensure the heater is plugged into a suitable socket, one that is tested for
outdoor use.
-To disconnect heater, turn controls to OFF, then remove plug from socket. Do not
unplug by pulling on the power cable.
-Always unplug the unit and ensure the unit is completely cold before moving,
cleaning or storing.
-This heater is intended for domestic use only and should not be used commercially
for contract purposes. Any alternative use, not recommended by the manufacturer,
may result in fire, electric shock, or injury to persons.
-The use of attachments on the heater is not recommended.
-Warning: This heater is not equipped with a device to control the room temperature.
Do not use this heater in small rooms when occupied by persons not capable of
leaving a room on their own, unless constant supervision is provided.
-Check exterior walls for areas of damage before installing the heater.
-Always use on a dry, suitably strong, stable, flat and level surface.
-Check exterior walls for communication and electrical cables and pipelines. Should
any service lines be present in the immediate vicinity do not install your heater, find
an alternative location to install this product.
-Do not position directly above or below an electrical socket.
-Do not remove any of the warning stickers or signs from the product.
04