Costway TY327933 User manual

Children Electric Tractor with Trailer
TY327933

Please read all instructions carefully and keep it for future reference.
Warnings:
Attention! Use it with protective equipment.
Attention! Not use it in the traffic.
Attention! The product is not suitable for the children under 3 years.
General Warnings:
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware.
Please ensure that all parts are correctly installed, incorrect installation can lead to a danger.
We recommend that, where possible, all items are assembled near to the area in which they
will be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during construction, und place the product always on a flat, steady
and stable surface.
Please use the product carefully, as the product requires great skill, avoid accidents by the
user or others, by fall or collision.
Please wear suitable protective equipment during use, e.g. protective helmet, gloves, knee
pads, elbow pads etc.
02 03

109*47*44 cm
151*68*70 cm
12V/900mA
3800-10000 550-10000
ra
Motor 22
front wheel / trailer wheel 2/ 2/2
04 05

Wrench
35
06 07

1
1.The rear wheel fender is clamped in the body of the corresponding
clamping slot, then the body is reversed, screws are installed in the
corresponding screw holes and tightened. (The rear guard plate has
7 screws on the left and 7 screws on the right, totaling 14 screws).
Rear Fender installation
1234
Use a screwdriver
to press the
shock absorbers
down into the rear
axle as shown
3
. Tighten a
M10
nut to the end of the
rear axle.
4.
Inset the
rear-
whee
l
hub to the
rear
wheel.
Repeat steps 1-4 for the other rear wheel.
Rear wheels
2
.Slide
a #
12
washer onto the rear axle.
1.First slide the motor to the rear axle, and then
slide the rear wheel to the back of the motor. Make
sure the rear wheels match the gearbox on the body
.
3
4
5
2
3.The Bogie is fixedly
connected with the
steering rod by a Split Pin.
4.The body turning sleeve is
provided with a mud plate
steering fixing part.
5.Use the M8 locknut to
screw it in place.
1
Insert the Bogie
into the body as
shown
2.
Front
1 Put the iron parts into the
Bogie and the #20 washer.
08 09

1
9.The car body link line with cable to plug the steering wheel.
35
Front
Slide a # 10 washer onto the front axle.
1. Slide a # 10 washer onto the front axle. Slide a front wheel bushing (shorter
plastic ring) onto the front axle.
M8
10 11

support shaft to the rear
support using a 4 * 25
2.As shown in figure:
INSERT THE REAR support
wheel axle clip into the rear
support.
1.
As shown: clamp the rear
screw and an M4 nut
.
#12
TWO
#8
#
Slide trailer bushing (longer plastic ring) on the trailer axle.
12 13

7
9
7
8
9
After the alignment connection
rod with connecting pin.
With card pin connection to
prevent
fall
.
8
Slide trailer bushing (longer plastic ring) on the trailer axle.
#
#
4
5
1
2
3
Music Player
Forward OR
14 15

Operation method:
First, open the battery cover on the back of the remote controller and
load two 1.5 VAAA alkaline batteries. Note: Correctly connecting the
positive and negative positions can prevent short circuit of power supply
terminals.
1. Turn off the power supply and press the pair key for 3-5 seconds. The
light flashes to turn on the power supply.
2. Forward and backward switch: According to the forward direction, the
stroller moves forward;
3. Emergency stop key: Control the stroller to stop in case of emergency
during driving.
4. Fast and slow gear: Adjust the speed of the tractor during driving.
5. The remote control key can be automatically turned on and
automatically turned off after being idle for about 2 minutes.
BACKWARD
SPEED SELECT
RIGHT
LEFT
STOP
CAR SELECT
FORWARD
16 17

18 19
Note: This tractor is equipped with charging protection function. All functions
of this tractor are unavailable when charging!
When charging, the power switch must be turned off.
It is recommended to charge for 4 ~ 6 hours before the first use, but not more
than 10 hours.
When the normal driving speed of the stroller slows down obviously, it means
that the battery is insufficient. Please charge it in time. Please charge for
8 ~ 12 hours after each use, but not more than 20 hours.
1. Insert the charger plug into the charging hole;
2. Plug the charger into the power socket;
FREQUENCY
(MHZ)
2402MHz
2403MHz
2404MHz
2405MHz
2406MHz
2407MHz
2408MHz
2409MHz
2410MHz
2411MHz
2412MHz
2413MHz
2414MHz
2415MHz
2416MHz
2417MHz
2418MHz
2419MHz
2420MHz
2421MHz
2422MHz
2423MHz
2424MHz
2425MHz
2426MHz
2427MHz
2428MHz
2429MHz
2430MHz
2431MHz
2432MHz
2433MHz
2434MHz
2435MHz
2436MHz
2437MHz
2438MHz
2439MHz
2440MHz
2441MHz
2442MHz
NUMBER
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
FREQUENCY
(MHZ)
2443MHz
2444MHz
2445MHz
2446MHz
2447MHz
2448MHz
2449MHz
2450MHz
2451MHz
2452MHz
2453MHz
2454MHz
2455MHz
2456MHz
2457MHz
2458MHz
2459MHz
2460MHz
2461MHz
2462MHz
2463MHz
2464MHz
2465MHz
2466MHz
2467MHz
2468MHz
2469MHz
2470MHz
2471MHz
2472MHz
2473MHz
2474MHz
2475MHz
2476MHz
2477MHz
2478MHz
2479MHz
2480MHz
2481MHz
2482MHz
2483MHz
NUMBER
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
FREQUENCY RANGE