Courtyard Creations TGS64SW-WM User manual

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS64SW-WM
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard any of the packaging until you have checked that you have all the parts and pack
of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by
children. Children should always be under direct adult supervision while using the product.
Retain the assembly instructions for future reference.
Please quote following FQC NO. when contacting service center.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
PAGE 1 OF 2 COURTYARD CREATIONS INC.
!
!
!
!
!
!
STOP DON’T RETURN TO STORE!
PARTS LIST
PART
NO. MATERIAL CODE PART Q’TY
1 1
2
3
4
5
7
6
8
9
10
11
4
2
8
4
4
4
1
4
1
6
TGS64SW-CS01
TGS64SW-CS02
TGS64SW-CS03
62TGS64SWY101
17C17A0403001Y4
17C33A0709001Y4
17C01A0709001Y4
17FA05040301-Y4
1800337004
1800337001
17KAA0101----Y4
TABLE TOP
LEG
SUPPORT
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*25
BOLT M6*25
WASHER d6.5*D13*1.0
BOLT CAP
BOLT CAP M6
HEX.KEY WRENCH 4MM
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #11)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) and supports (#3) into the plastic
holders on the table top (#1) rim. Fasten them together
by using screws (#5). See Figure 1.
Attention:
Make sure that each bolt needed for all steps match the
corresponding figure to ensure proper assembly.
1
22
22
3
35

Missing A Part?
No Need To Go Back To
TheStore!
The store where you made your purchase
does not stock parts for this item
if you need parts,
whether they are missing or damaged.
Call Toll Free
TEL: [phone]
FAX: [phone]
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
The store where you made your purchase
does not stock parts for this item
if you need parts,
whether they are missing or damaged.
STOP!
MissingAPart?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
Call Toll Free
TEL: [phone]
FAX: [phone]
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
PLEASE SEPARATE AND IDENTIFY ALL PARTS, MAKING SURE THAT YOU
HAVE ALL OF THEPARTSLISTED.
SHOULD YOU NOTLOCATE ALL OF THE ABOVE PARTS, PLEASE INSPECTALL
PACKING MATERIAL FOR ANYSMALL PARTSTHAT MAYHAVEBECOME
SEPARATED IN SHIPMENT.
SHOULDYOU EXPERIENCEANYDIFFICULTYDURING ASSEMBLYOR IF ANY
PARTIS MISSING OR DAMAGED,PLEASE CALL THE HELP LINE 1-877-539-7436
BEFORERETURNING THEITEM TO THESTORE.
PLEASE PROVIDE THEFOLLOWING INFORMATION:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS LIST
SHOWN ON ASSEMBLY INSTRUCTIONS.
MOST PROBLEMSCAN BERESOLVED WITHOUT RETURNING THIS PRODUCT
TO THERETAILER.
PAGE 2 OF 2
STOP DON’T RETURN TO STORE!
FIGURE 2 FIGURE 3
FIGURE 4
Step 2:
Fasten the center connector with ring (#4) to the middle
of the legs (#2) by using bolts (#6) and washers (#8).
Keep the bolts loose. See Figure 2.
Step 3:
Fasten the center connector with ring (#4) to the supports
(#3) by using bolts (#7) and washers (#8). See Figure 3.
Make sure that all of the bolts have been tightened
completely, and then cover them with bolt caps (#9
and #10).
NOTE:
The arrow mark on the center connector with ring (#4)
must coincide with figure 2 to ensure proper assembly.
Step 4:
Turn the table to its upright position. See Figure 4.
Cleaning and Maintenance
•Wash frame parts with mild soap and water, rinse
thoroughly, and dry frame completely. Do not use
bleach, acid, or other solvents on the frame parts.
•Wash glass with mild soap and water, rinse thoroughly,
and dry glass completely.
•Please inspect and tighten all bolts and fasteners on
a regular basis to ensure proper performance and
safety of your table.
•When moving the table, remove the umbrella and lift
the table. Do not drag.
•We recommend the use of furniture covers when not
in use.
•In order to prolong the life and beauty of your table,
we recommend it be stored in a dry and protected
area during off season periods.
•Tempered glass has been used for increased strength
and safety of your table. However, during windy
conditions the umbrella should be lowered and/or
removed.
22
2
2
43
3
22
2
2
43
3
6
8
9
7
7
8
8
10
10
25
#6 BOLT M6*25 #7 BOLT M6*25 25
NOTE:
To use an umbrella with this table, please remove the
plastic center plug and put the umbrella pole through the
table top and center connector ring.