Covalon Technologies AquaGuard Boot User manual

Keep your wounds and
dressings dry during a shower.
3
Gloves
aCovalonTechnologies Ltd. Product
SHOWER PROTECTION
GLOVE
WITH WATER-SEAL BAN D ®
SHOWER PROTECTION
BOOT
WITH WATER-SEAL BAND®
Keep your casts,
wounds and
dressings dry
during a shower.
3
Boots
a Covalon Technologies Ltd. Product

Reorder Number: 50017
LS-916-0. 01/2019
NOTE:
1. While seated with knee flexed slide boot over leg and
above the site to be protected, leaving some slack in the boot
for movement.
2. Press and hold lever down to completely open buckle as shown.
3. Slide Water-Seal Band®over boot and above site to be protected.
4. Pull loose end of the band until the buckle is snug against leg.
Confirm an effective seal by attempting to insert afinger
underneath band.
5. Secure excess band material by wrapping around leg.
6. Fold excess boot material over band toform cuff.
7. After shower gently pat cuff and surrounding area dry before
removal.
8. Remove buckle by pressing and holding lever while drawing
buckle away from leg.
CAUTION:
• Boot can be slippery when wet. Please use caution.
• Suffocation hazard. Keep out of reach of children.
• Do not use if punctured or worn.
1-888-236-4944
Tukwila, Washington 98168
Visit us at www.aqua-guard.com
Made in USA
LATEX FREE • Non-Sterile
DIRECTIONS FOR USE
Some dampness may occur inside boot due to perspiration.
Boot may be trimmed to size.
•
•
aCovalon Technologies Ltd. Product