DIN-AP4
DINRail 4-Series Control System
Product Information - 8537A
(2054547)
05.20
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8514
For additional information on the Crestron® DIN-AP4, visit
www.crestron.com/model/6510417.
Pair with Apple® HomeKit® Technology
The DIN-AP4 can be paired with Apple® HomeKit® technology to
enable communication between the control system and Apple
HomeKit devices and accessories.
To pair the DIN-AP4 with an Apple HomeKit system, open the Apple
Home app on an iOS® device, and then use the device camera to scan
the QR code provided below.
NOTE: To ensure the control system is paired with the homeowner's
Apple HomeKit system, the QR code must be scanned by an iOS
device associated with the homeowner's Apple ID.
lFor more information on pairing the device with an Apple HomeKit
system, refer to https://support.apple.com/en-us/HT204893.
lFor more information on integrating the control system with
Apple HomeKit devices, refer to
www.crestron.com/Partners/Integrated-Partners/Apple.
Certification and Compliance
Regulatory Model: DIN-AP4
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment and receiver.
lConnect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
lConsult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of the date of manufacture, the product has been tested and
found to comply with specifications for CE marking.
This product is Listed to applicable UL® Standards and requirements
tested by Underwriters Laboratories Inc.
Ce produit est homologué selon les normes et les exigences UL
applicables par Underwriters Laboratories Inc.
The Waste Electrical & Electronic Equipment (WEEE) directive
marking on a product indicates that it should not be disposed of with
general waste. Instead, you are encouraged to reuse or recycle the
product in accordance with Directive 2012/19/EU of the European
Union. Proper disposal of this product will help prevent potential
negative effects on the environment and human health, which could
otherwise be caused by inappropriate waste handling. Penalties may
be applicable for incorrect disposal of this waste, in accordance with
your national legislation. For information about recycling this
product, please contact your household waste disposal service, your
original distributor, or Crestron.
