Crestron FlipTop FT2 Series User manual

FT2-1200-MECH-PTL
FlipTop™ FT2 Series Cable Management System, 1200 Size, Mechanical, Pass-Through Lid
DocType - 9080A
(2058222)
07.21
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/9081

For information on the Crestron®
FT2-1200-MECH-PTL, visit
www.crestron.com/model/6511656.
Certification and Compliance
Regulatory Models: FT2-1200-MECH-AL,
FT2-1200-MECH-B
As of the date of manufacture, the product has
been tested and found to comply with
specifications for CE marking.


Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment
and receiver.
lConnect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
lConsult the dealer or an experienced radio/TV
technician for help.

Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)

Legal
The product warranty can be found at
www.crestron.com/warranty.
The specific patents that cover Crestron products
are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source
software. For specific information, visit
www.crestron.com/opensource.


Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: [phone]
www.crestron.com
Product Information - Doc. 9080A
(2058222)
07/09/21
Crestron, the Crestron logo, and FlipTop are either
trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other
countries. The RU logo is either a trademark or
registered trademark of Underwriters Laboratories,
Inc. in the United States and/or other countries.
Other trademarks, registered trademarks, and
trade names may be used in this document to refer
to either the entities claiming the marks and names
or their products. Crestron disclaims any
proprietary interest in the marks and names of
others. Crestron is not responsible for errors in
typography or photography.
©2021 Crestron Electronics, Inc.

 