CrimeStopper BackStopper CA-5006 User manual

CA-5006
Reverse Parking Sensor
with Extended Display Cable
for RV/Coach installation
Features:
•50 FT Extended Display Cable
•Multi-Colored Bar Graph Display Indicates
Distance to Object, Left Right Side and.
Numerical Distance Display
•Audible Tones With Three Distinct Warnings
•Compact Sensor Design
DISCLAIMER:
Under no circumstances shall the manufacturer or distributor of the
BackStopper™ be held liable for consequential or incidental damages sustained in
connection with the use or installation of the BackStopper™ Rear Detection
System. The BackStopper™ is designed as a safety enhancement device and is
in no way intended as a replacement for rear-view mirrors, side-view mirrors or
physically checking the surroundings when backing a vehicle. Always check
surroundings for safety when backing!

+12V Back up Light
RED
BLACK
Ground
Beeper
Display
(Front Mount)
Control System
CA-5006 SYSTEM DIAGRAM
Sensors
LR
L1 R1
50 Ft.
(Extended
Cable)
(Rear mount)
LOCATING THE SENSORS:
20 Inches from center of sensor to ground level

SENSOR INSTALLATION:
1. Carefully measure and mark sensor locations. Measure, double-
check and check again. You are making permanent modification
to the vehicle, make sure spacing and angles are correct!
2. Use the supplied 22MM hole sale drill to make sensor holes.
3. Route cable through hole.
4. Gently press in sensor. Hole clearance is critical, make sure
sensor fits snugly, but not over-tight. Crushed sensors will provide
inaccurate readings and false triggers.
1.
2.
3.
CA-5006
Surface Mount Sensor
4.

SENSOR ANGLE:
SIDE VIEW
Horizontal
!
Ground may interfere.
0-10 degree upward
Optimum
performance
Downward
O.K.
(May not detect
small or low to
ground objects.)
Tech Support [phone]
OPTIONAL ACCESSORIES (Not included)
•CA-504BRKT-Under bumper bracket for hanging sensors below
bumper level.
Crimestopper Security Products Inc.
1770 S. Tapo St.
Simi Valley, CA 93063
[phone]
www.crimestopper.com
[email protected]