Croydex Chetsford Series User manual

1
Chetsford Range
Thank you for purchasing this Croydex product. Please follow the xing and care instructions to ensure
your product is tted safely and retains its high quality nish.
Please retain this leaet for future reference.
This installation guide applies to the following cabinets:
WC010522 - Chetsford Floor Standing Tall Cupboard
Tools required - not supplied
Pencil;Tape Measure; Philips Screwdriver; Drill; 8mm Drill Bit (Ceramic drill bit optional).
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Home Safety Advice
- It is recommended that two people t this product to ensure that it is tted safely.
- Always take care when using power tools, particularly in the bathroom.
- Always check for hidden cables and pipework before drilling and take extreme care if there is any
water in the working area.
- It is advisable to use a residual current circuit breaker (RCCB).
- Always wear suitable eye protection when drilling.
- If the product is to be tted on a ceramic tiled wall, a ceramic drill bit should be used.
- Always ensure that the drill hole passes through the central tiled area rather than through the grouted
area. To prevent damage to the tile, mask the area around the hole with tape before drilling.
- Do not strike the product with hard or sharp objects.
Product Care
To retain the best quality nish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners as these will damage the product.
CAB 102 R01

CAB 102 R01
2
For details of the other items in the Croydex range please visit
our website: www.croydex.com
Croydex Ltd, Central Way, Andover, Hants, SP10 5AW, UK
Tel: [phone]
Fax: [phone]
Email: [email protected]
Lay product down and install support
legs by rotating in clockwise direction.
The product needs to be lifted into an
upright position by 2 people to avoid any
damage to the support legs.
Please note that a safety
bracket is situated on the rear
of the cupboard. This bracket
ensures the cupboard can not
fall forward during use.
In order to determine the
position of the retaining hook
on your wall surface measure
the distance from the oor
surface to the bottom edge of
the bracket on the rear of the
cupboard.
Support Leg Installation
Floor Standing Cupboard
Door Handle Installation
x 2
Once the bracket position has been measured,
use a pencil to mark the position of the retaining
hook on your wall surface.
With an 8mm drill bit, drill into the wall surface.
Insert the wall plug and screw the retaining hook
into position.
Complete the assembly by lifting the cupboard
onto the retaining hook.