Croydex QA200021 User manual

MIR 046 R02
1
QA200021
BLACK METAL FRAMED
MIRROR WITH MATT BLACK
CHAIN
ALL PRODUCT DIMENSIONS DETAILED IN THIS INSTALLATION
AND MAINTENANCE MANUAL ARE APPROXIMATE
ALL ILLUSTRATIONS OF THE PRODUCT ARE FOR REFERENCE
ONLY. COMPONENTS SUPPLIED WITH INDIVIDUAL PRODUCTS
MAY DIFFER
CONTACT DETAILS
Croydex
Central Way
Andover
Hampshire
SP10 5AW
UK
Tel: [phone]
Email: [e-mail]
www.croydex.com
SECTION 1 - INTRODUCTION
Please follow all assembly and product care instructions to ensure that your
product is assembled safely and retains it's high quality finish.
Before attempting to fit or use this product ensure that it can be properly
installed in the desired location.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
x1
SAFETY & PRODUCT CARE
1. ALWAYS take care when using power tools, particularly if there is any
water in the working area.
2. ALWAYS wear eye protection when using power tools.
3. ALWAYS check for pipes and cables before drilling into walls.
4. NEVER use a hammer drill when drilling into tiled surfaces.
5. ALWAYS use a drill bit that is suitable for the surface that is being drilled.
6. DO NOT use abrasive or chemical cleaners as these may damage the
product.
7. DO NOT strike the mirror with hard or sharp objects.
TOOLS REQUIRED
x1 wall
screw
x1 wall
plug
WALL FIXING PACK
Dimensions: H580 x W382 x D20mm

MIR 046 R02
2
SECTION 2 - INSTALLATION
INSTALLATION WITH CHAIN
1. While holding the mirror up to
the wall via the chain - mark the
point at which the mirror should
hang from.
(See Fig. 1)
fig. 1
2. Drill a 6mm hole in the marked
point.
(See Fig. 2)
3. BEFORE HANGING THE MIRROR ENSURE THE WALL FIXING IS SECURE!
Hang the mirror from the wall fixing. Ensure the chain is of an
equal length on both sides to ensure that the mirror is level.
ENSURE THE MIRROR IS SECURELY HELD BEFORE LETTING GO!
(See Fig. 3A & 3B)
fig. 2
fig. 3Bfig. 3A
=
INSTALLATION WITHOUT
CHAIN fig. 4
2. Measure 90mm vertically down
from the marked line and mark
this location.
Then drill a 6mm hole and insert
the wall plug.
(See Fig. 5)
fig. 5
90mm
3. BEFORE HANGING THE MIRROR
ENSURE THE WALL FIXING IS SECURE!
Hang the mirror from the wall
fixing using the keyhole slot on the
back.
ENSURE THE MIRROR IS SECURELY HELD
BEFORE LETTING GO!
(See Fig. 6)
fig. 6
1. Detach the split ring and chain
from the mirror. Then hold the
mirror up to the wall in the desired
position. Mark the location of the
top edge on the wall.
(See Fig. 4)