FURNITUREBOX GIOVANI CONSOLE TABLE User manual

GIOVANI CONSOLE
TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/giovani-console
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 2
Place console top on
at surface, upside
down so holes face
upwards.
Align connecting
plate with holes in
console top and
attach using 1 x
washer [B] followed
by 1 x screw [C] per
hole. Tighten with
Allen key [D]
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches.
First, attach connecting plate to
halo using 1 x washer [B] followed
by 1 x screw [A] per hole. Tighten
with Allen key [D].
ATTENTION: To ensure table
stability, please make sure you
have fully tightened the halo to
the connecting plate.

www.furniturebox.co.uk
STEP 3
Attach console table base
to halo using 1 x washer [B]
followed by 1 x screw [A] per
hole. Tighten with Allen key
[D] Attach feet [E] to corners.
STEP 4
Carefully, and with help,
turn your console table over
so it rests on its base. Check
for stability. Your console
table is now ready to use.
FULL ASSEMBLY INSTRUCTIONS