4
Submit
Network Name (SSID)
WPA2 Security Key
No Security
Device Name
Email Address 1
Email Address 2
Text Message Phone Number 1
Text Message Phone Number 2
Notification Setup
ubmi
IP Address: 10.4.150.148
MAC Address: A1:B5:C3:D2:E7:C2
Battery Status: None (Hit F5 to refresh)
At least one email address or one phone number must be provided to receive notification messages.
Example: 123-456-7890
Example: 123-456-7890
STEP 3: Alarm Notication Setup
1. On the CS1200 WiFi Alarm setup
page,llintheappropriatedata:
Note: Steps a. and b. are only required
if connecting to a wireless network that
does not support WPS connection.
a.NetworkName(SSID):Enterthe
wireless router’s network name,
also called SSID, as it appears on the
WiFi connection for your Smart Phone,
Tablet, Laptop, or Desktop Device.
b. WPA2SecurityKey:Enterthe
wireless router’s security key
(password).
Or
Check the “No Security” box if the
wireless network does not require a
password.
c. DeviceName:EnterauniquedevicenameforeachCS1200 WiFi Alarm being installed.
EXAMPLE: “Cabin Sump Alarm”. Maximum 30 characters including spaces.
d. EmailAddress(es):Fillintheemailaddress(es)whichwillbe receivingnoticationsfromthe
CS1200 WiFi Alarm.
e. Enter the phone number of the device (or devices) that will receive the text messages.
Note: A minimum of one email address or text message phone number must be entered to
receivealarmnotications.
2. ClickSubmitbuttontosaveyournoticationdata.
3. If connecting to a wireless network that does not support WPS connection, enter the router’s
Network Name (SSID) and WPA2 Security Key, then disconnect the ethernet cable. Remove the
backup battery and disconnect the power cord from the power receptacle. Once the green power
light is no longer illuminated, plug the power cord back into the power receptacle.
The blue network status light will illuminate steadily when
the CS1200 WiFi Alarm is successfully connected to the
wireless network.
INDOOR ALARM SYSTEM
120 VAC
CS1200
WiFi
Replace battery yearly
