Curt Manufacturing 56165 User manual

INSTALLATION INSTRUCTIONS
CUSTOM WIRING HARNESS
WIRING LOCATION GUIDEAPPLICATIONS
NOTICE
WARNING
TOOLS NEEDED
Signal Circuits - 3.0 amps per side
Tail / Running Circuits - 6.0 amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
Ratchet
10mm socket
Phillips screwdriver
Panel trim removal tool
The battery connection must be fuse-protected, 10-amp max.
Exceeding the product rating can cause loss of warranty,
overheating and potential fire. Do not exceed product rating
or tow vehicle lamp load rating, whichever is lower.
Make Model
Toyota Rav4
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
SUVS, MINI & FULL-SIZED VANS (S)
Representative vehicle shown below
S3 - Behind driver side rear access panel
S4 - Behind passenger side rear access panel
S3 S4
All steps must be followed to ensure the wiring harness
will function properly. Once installed, test for proper function
by using a test light or connecting a properly wired trailer.
PAGE 1 • 56165-INS-RB

A B C
D
Step 1
Open the vehicle tailgate. Remove the rear scuff panel, trunk
floor coverings, storage covers and the privacy screen (A,B).
Step 2
On both sides, remove all trim fasteners and slightly pull
out on the rear trim panels to locate the vehicle taillight wiring
harness connectors. The connectors will be similar to those on
the custom wiring harness C,D).
Step 3
Starting on the driver side, separate the connectors from the
taillight housing taking care not to damage the locking tabs.
Step 4
Insert the custom wiring harness end with yellow wire
between the separated connectors. Make sure the
connectors are fully inserted with locking tabs in place.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Route the custom wiring harness end with the green wire to the
passenger side behind the removed scuff panel. Repeat steps
3 and 4 on the passenger side using the harness end with the
green wire.
Step 7
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 8
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 9
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 10
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION /SAFETY INSTRUCTIONS
56165-INS-RB • PAGE 2