CyberData 011201 Manual

The IP Endpoint Company
Quick Reference 930483E © 2019, CyberData Corporation, ALL RIGHTS RESERVED.
Installation Quick Reference
Ceiling Tile Auxiliary Analog Drop-In Speaker 
011201
Parts
(1) 1 x 2 Ceiling Tile Speaker Assembly
FIts 12-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) Cross Tee
Dimensions
23.625 [600]
11.750 [298.5]
Approx. 3.510 [89.2]
Dimensions are in
Inches [Millimeter]
Contacting CyberData
Sales: [phone] ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: [phone] ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA

Phone: [phone]
Fax: [phone]
http://www.cyberdata.net/

© 2019, CyberData Corporation, ALL RIGHTS RESERVED. 930483E Quick Reference
Installation Procedure
To install the Ceiling Tile Auxiliary Analog Drop-In Speaker, complete the following steps while referencing the figure
below:
1. Remove the Ceiling Tile (Showing a 2 x 2 Grid) from the Ceiling Grid then Cut it in Half.
2. Place the Cross T in the Middle to Support the Weak Side of the Ceiling Tile.
3. Replace the Ceiling Tile on to the Ceiling Grid.
4. Use a Flat Blade Screwdriver to Pry Up the Seismic Tether Bracket(s) on the 1 x 2 Ceiling Tile Speaker
Assembly.
5. Install Eyebolt(s) or Nail(s) to the Joist.
6. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 1 x 2 Ceiling Tile
Speaker Assembly.
7. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 1 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T.
Installing the Ceiling Tile Auxiliary Analog Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
Cross T
*
*
**
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
1 x 2 Ceiling Tile
OLD
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
Cross T
*
*
**
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
1 x 2 Ceiling Tile
2
8
4
5
1, 3
6
7