CyberData Syn-Apps 011522 Manual

Quick Reference 931747A © 2020, CyberData Corporation, ALL RIGHTS RESERVED.
Parts
FIts 24-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) Syn-Apps Enabled 2 x 2 Ceiling Tile Drop-In Speaker Assembly
Dimensions
23.8 [605]
3.0 [77]
23.8 [605]
Dimensions are in Inches [Millimeter]
Contacting Syn-Apps
Corporate Headquarters
Syn-Apps LLC
2812 N Norwalk
Suite 112
Mesa, AZ 85215

Phone: [phone]
Fax: [phone]
Website: www.syn-apps.com

Sales: [email protected]

Support: http://www.syn-apps.com/resources/support
Email: http://www.syn-apps.com/contact-us
Installation Quick Reference
Syn-Apps Enabled 2 x 2 Ceiling Tile Drop-In Speaker

011522

© 2020, CyberData Corporation, ALL RIGHTS RESERVED. 931747A Quick Reference
Installation Procedure
To install the Syn-Apps Enabled 2 x 2 Ceiling Tile Drop-In Speaker, complete the following steps while referencing
the figure below:
1. Remove the Ceiling Tile (Below Figure Showing a 2 x 2 Grid) from the Ceiling Grid. Cut the 2 x 4 Ceiling Tile in
Half if using a 2 x 4 Grid.
2. Place the Cross T* in the Middle for Support (Only on a 2 x 4 Grid).
3. Use a Flat Blade Screwdriver to Pry the Seismic Tether Bracket(s) on the 2 x 2 Ceiling Tile Speaker Assembly.
4. Install Eyebolt(s) or Nail(s) to the Joist.
5. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 2 x 2 Ceiling Tile
Speaker Assembly.
6. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 2 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T* (see Step 2).
Installing the Syn-Apps Enabled 2 x 2 Ceiling Tile Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
*
*
*
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
*
Remove
Ceiling Tile
Install Cross T (Not Included)
Only on a 2 x 4 Grid
1
2
Drop-in the 2 x 2 Ceiling Tile Speaker Assembly
6
3
4
5
Cross T