D-Link DAP-1520 Technical manual

Your WiFi Configuration Card which is included in
the box. See image below
Correct placement of the WiFi Extender is very important
Plug your Extender into a power outlet located in an area that
still receives good signal from your wireless access point. A
good starting point is approx half way between the access
point and the area you want to get signal to
Quick Placement Tips
Access Point
Access Point
1.
2.
3.
4.
http://www.deltacable.com/Internet/WiFi/WiFiModemFAQ.aspx

Solid Green Successfully connected to a network
Solid Red Device is booting up
Blinking Red The device is in recovery or the device malfuctioned
Blinking Amber Device is powered on, but not connected to a network
Off Device is not receiving power
Power Status LED
1. Plug your WiFi Extender into a power outlet and wait for a blink-
ing amber status to show on the indicator LED
3. Click on the Wireless Network Name (SSID) for your WiFi Extender
and connect. It will appear as a name closely resembling dlink-XXXX,
the last four characters vary by device. This will allow your computer
or mobile device to link to your new WiFi Extender.
Locate your WiFi Configuration Note/Card for more information
on the exact Wireless Network Name (SSID) of your WiFi
Extender
These last four
characters will be
different with each
device
Power Status LED

4. Enter the password found on your D-Link WiFi Configuration
Card and click ‘OK’ to connect. You will now see the status of your
unit change to ‘Connected’.
5. To configure the WiFi Extender, open a web browser and enter
http://dlinkap.local./ Windows XP users can enter http://dlinkap.
(Choose from Internet Explorer, Firefox, Safari or Chrome)
6. Once on the web page, the login will appear.
Enter your password and click Log In. By default the password is
blank. If this is the first time logging in to your WiFi Extender,
you will be directed to the Setup Wizard automatically.
1. Select your Language
2. Select option to setup network manually
(Note: WPS not supported)
3. The setup wizard will now scan your home for WiFi signals
4. Select the WiFi network you wish to pair your WiFi Extender with
Setup Wizard
Note: The WiFi network names above will vary

Congratulations – you are ready to connect any device to your
extended WiFi network.
If you need assistance at any time, please call 604-946-7676
5. Enter the WiFi Password, if applicable, required to connect with
the network you choose
6. The Setup Wizard will automatically populate the fields as shown
Note: Device may take up to 20 seconds to connect with your WiFi network
7. Device will reboot and save your settings
8. The home page will display your current status: A green check
mark represents a successful connection to your wireless modem or
Access Point (AP).
If a red X appears between the Uplink router and the DAP-1520, you may
troubleshoot this issue by clicking on the Uplink Router icon.
Note: Your changes are being saved, and the device will need to reboot
Your existing home network name will be carried over from
the previous screen, EXT added for the 2.4 GHz band and
EXT5G added to the 5 GHz band
The same password used to connect to your home network
will be pre-populated in the password fields
The default settings will work effectively. Simply click Next.