D-Link DRA-2060 Manual

Technical Support Setup Procedure
Page | 1
How to setup DRA-2060 as mesh extender?
Step 1: Connect to current Exo mesh router
Wifi.
Step 2: Open D-Link Wi-Fi Apps on the
Android mobile device.
Step 3: Click on Menu Icon.
Step 4: Click on Install New Device.
Step 5: a) Click on Scan the QR code.
b) Scan the QR code on the device.
Step 6: a) Ensure you are connected to your
Wi-Fi Network.
b) Click on Next
Step 7: Wait for Detecting device to finish.

Technical Support Setup Procedure
Page | 2
Step 8: Click SELECT under Wirelessly.
Step 9: a) Power on DRA-2060.
b) Click on NEXT.
Step 10: Wait for the device to boot up
Step 11: a) Ensure the LED at the side of the device
start to blink orange.
b) Click on NEXT.
Step 12: a) Connect ethernet cable from
DRA-2060 to the router.
b) Click on Next.
Step 13: Wait for the Syncing to be finish.

Technical Support Setup Procedure
Page | 3
Step 14: a) Place DRA-2060 to the middle of the
home.
b) Click on NEXT.
Step 15: a) Power on the device .
b) Click on NEXT.
Step 16: a) Wait for the status LED turn to solid
green on the device.
b) Click on NEXT.
Step 17: Click on NEXT.
--- END ---