D-Link DAP-1860 Manual

Technical Support Setup Procedure
Page | 1
How to configure DAP-1860 as Access Point with default wireless
SSID.
(Note Please ensure the device LED is blinking orange colour before you do
setup.
If it is not blinking in orange colour, follow the guide on page 2 on how to reset
the device before follow the guide to setup.)
Step 1: Copy down the wireless name and password that was on the sticker of the device.
Step 2: a) Plug DAP-1860 direct to power outlet.
b) Connect LAN Cable from DAP-1860 to LAN port of the Router.
Step 3: Click on the Computer Icon on the right bottom side of the indows. Select the Wire ess
network name that was copy down.

Technical Support Setup Procedure
Page | 2
Step 4: Enter the Wifi Password which had copy down earlier on. Click on OK.
Step 5: You are now connected to the DAP-1860 and use the internet.
--- END ---
How to reset DAP-1860.
Step 1: Plug DAP-1860 direct to power outlet.
Step 2: Power on DAP-1860 and wait for 1 min.
Step 3: Use a paper clip to press and hold the Reset Button for 30 second.
Step 4: ait for 2 min for the device to fully power on after reset.
--- END ---