D-Link DES-1005D User manual

Before You Begin
DES-1005D
10/100M Fast Ethernet Switch
This Quick Installation Guide gives step-by-step instructions for setting up the D-Link
DES-1005D 10/100M Fast Ethernet Switch. The model you have purchased may
appear slightly different from those shown in the illustrations. For more detailed
information about the switch, its components, making network connections and
technical specifications, please refer to the User’s Guide included you’re your switch.
Check Your Package Contents
These are the items included with your DES-1005D purchase:
• DES-1005D 10/100M Fast Ethernet Switch
• User Manual
• Quick Installation Guide
• DC Power Adapter
Using a powe
r
supply with a
different voltage rating
will damage and void
the warranty for this
product.
If any of the above items are missing, please contact your reseller.
©2003,2005 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their
respective holders. Software and specifications subject to change without notice.

2
Unpacking
Please make sure the following items are present and undamaged.
3.Rubber Feet
4.Screws and Anchors
1.The switch
2.AC Power Adapter
Physical Installation
Putting the Rubber Feet
For desktop installation, please take time now to attach the included rubber feet to
the base of the switch.

Mounting Switch on Wall
The DES-1005D can be mounted on a wall. Two mounting slots are provided on
the bottom side of the hub for this purpose. Make sure that the front panel is
exposed to allow you to view the LEDswhile the unit is on.
PC to DES-1005D
A PC can be connected to the Switch via a two-pair Category 3,4, or5 UTP/STP
straight-through cable. For 100Mbps operation Category 5 must be used. The PC
(equipped with a RJ-45 10Mb Ethernet or 100Mb Fast Ethernet NIC) should be
connected to any of the 5 ports (1 - 5) for the DES-1005D.
3

The LED indicators for PC connection depend on the LAN card’s capabilities. If LED
indicators are not lit after making a proper connection, check the PC LAN card, the
cable and the DES-1005D conditions and connections.
1. The “100LINK/ACT,10LINK/ACT” LED indicator lightsgreen for hookup to
100Mbps speed or light amber for hookup to 10Mbps speed.
Hub to DES-1005D
4
A
The
hub (10 or 100BASE-TX) can be connected to the DES-1005D via a two-pair
Category 3, 4, 5 UTP/STP straight cables. For 100Mbps operation a Category 5
cable must be used. The connection is accomplished from any port of the hub to any
port of the switch.
DES-1005D to switch
DES-1005D can be connected to another switch or other devices (routers,
bridges, etc.) via a two-pair Category 3, 4, 5 UTP/STP straight or crossover cable. A
Category 5 cable must be used for 100Mbps operation. The connection can be done
from any (MDI-X) port of the Switch (Switch A) to any of the 10Mbps, 100Mbps (MDI-
X) port of the other switch (switch B) or other devices.
Additional Information
If you are encountering problems setting up your network, please refer to the User’s
Guide that came with the switch. It contains many more rules, charts, explanations
and examples to help you get your network up and running.
Additional help is available online at http://www.dlink.com in the United States, at
http://www.dlink.co.uk in the United Kingdom, or through our offices listed at the back
of the User’s Guide.