D-Link DSL-502T Instruction Manual


InstallingD‐LinkDSL502T–
USB Drivers
Excerpt from Bas-XConnect Help files
©Bas-XConnect Pty Ltd 2009

©Bas-XConnect Pty Ltd 2009
USING USB PORT ON D-LINK DSL502T
Generally, the Ethernet connection is more reliable than a USB connection. In case you need to use the
USB port on the router, the following instructions will guide you through the setup process.
IMPORTANT: Do not connect the USB cable to your PC before completing the below steps.
To install USB driver follow these instructions:
1. Insert D-Link CD to CD-ROM drive. Installation Wizard will start. Close this page, as we do not need
to run this installation wizard now.
2. Double left-click on the My Computer icon (on your Desktop). Or if you don’t have the My Computer
icon on your Desktop, click Start >>My Computer (Computer for Windows Vista users).
In the My Computer window, locate “DSL-502_1.03” icon (like it is shown in the picture), Right-Click
on the icon and then select “Explore”. Windows Explorer will start, and you will be able to see the
content of the “DSL-502_1.03” CD.
3. Double-Left Click on USB Driver folder
4. Double-Left Click on Setup.exe (this will start the installation wizard)

©Bas-XConnect Pty Ltd 2009
5. Click on Next, to continue with installation.
6. Click on Install.
7. Click on Finish, to confirm that installation is done.
8. Connect the router to the USB port on your computer. Turn the router on. In the bottom right
corner on your screen, you should see Found New Hardware DSL-502T icon.
You are now ready to use your DSL router.