D-Link DSL-G225 User manual

How to setup the DSL-G225
in Bridge Mode

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 2of 11
This guide is for DSL-G225 with firmware ver. 1.04.
Before proceeding with this setup please set your computer temporarily with a static IP address from
192.168.1.x range (e.g. 192.168.1.99):
Open your Internet browser e.g. Internet Explorer, Firefox, Chrome, Safari, etc. and enter the IP address of your D-
Link modem in the address bar: http://192.168.1.1.
When prompted, type in the Password. If you have not changed the password for the modem administration, the
factory password is “admin”.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 3of 11
There are two ways to setup your modem in Bridge Mode: using the Setup Wizard and using Manual
Configuration.
Setup using the Setup Wizard
Step 1. After logging into the modem’s configuration pages, go to SETUP > Local Network.
Un-check the “Enable DHCP Server”option.
Click on Save/Apply.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 4of 11
Step 2. Go to SETUP > Wizard > click on the “Setup Wizard” button.
Follow the steps in the Setup Wizard.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 5of 11
Choose ADSL or VDSL, depending on the type of technology used for your Internet connection.
Set Protocol to “Bridge”.
It is recommended to disable the modem’s Wi-Fi:

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 6of 11
Click on “Save/Apply” to finish the Setup Wizard. The setup is complete.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 7of 11
Manual Setup
Step 1. After logging into the modem’s configuration pages, go to SETUP > Local Network.
Un-check the “Enable DHCP Server”option.
Click on Save/Apply.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 8of 11
Step 2. Go to SETUP > Internet Setup.
If there are any existing profiles listed in the WAN Setup table, delete them.
Choose ADSL or VDSL, depending on the type of technology used for your Internet connection.
Click on “Add”.
Set Protocol to “Bridging” and click on Next.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 9of 11
Click on “Apply” to finish the setup. The modem setup is complete.

D-Link Technical Support –How to setup DSL-G225 in Bridge Mode Page 10 of 11
Please note that in Bridge Mode the DSL-G225 modem acts as a transparent device. If your Internet
provider requires PPPoE authentication or VLAN tagging, you need to enable these options on the device
connected to the LAN port of the DSL-G225 modem.
After successful VDSL sync