D-Link R15 Manual

Technical Support Setup Procedure
How to restore the R15 router to Factory Defaults?
Step 1:
Connect your device to the Wi-Fi of the R15 router.
Step 2:
Open a browser and type http://R15-XXXX.local./ or http://192.168.0.1 then press Enter
*XXXX Last 4 digit of the router’s mac address
Step 3:
Enter your administrator password.
If you have not changed the default password, check on the configuration card. Click Login.

Technical Support Setup Procedure
Step 3: Go to Management > System Admin > System
i. Put your desired admin password in the Password box
ii. Click Restore Button
iii. Click OK
iv. Wait for the countdown
v. Restore to factory default successful
Please note that restoring the settings to the factory defaults will erase all settings, including any rules you have created

Technical Support Setup Procedure
Reset Pin hole
1. Keep the router powered on
2. Insert a paperclip in the hole
3. Wait for the power LED turns orange (all other LEDs should be off)
4. Release to reset the router to default settings.
Please note that restoring the settings to the factory defaults will erase all settings, including any rules you have created
--End--