Da-Lite EXECUTIVE ELECTROL User manual

SQUARE FORMAT DIMENSIONS (screens with ^ have 2" standard black drop at top)
Sizes *Overall Length of Case Approx. Ship. Wt.
H x W Cm In. Cm Lbs. Kg
50" x 50" 127 x 127 761/2"194 144 65.3
60" x 60" 152 x 152 861/2"220 154 69.9
70" x 70" 178 x 178 961/2"245 164 74.4
84" x 84" 213 x 213 1101/2"281 184 83.5
6' x 8'^ 183 x 244 1221/2"311 209 94.8
8' x 8' 244 x 244 1221/2"311 211 95.7
7' x 9'^ 213 x 274 1341/2"342 234 106.1
9' x 9'^ 274 x 274 1341/2"342 237 107.5
8' x 10'^ 244 x 305 1461/2"372 260 117.9
10' x 10'^ 305 x 305 1461/2"372 263 119.3
9' x 12'^ 274 x 366 1701/2"433 311 141.1
12' x 12' 366 x 366 1701/2"433 316 143.3
10'6" x 14'^ 320 x 427 1941/2"494 403 182.8
14' x 14' 427 x 427 1941/2"494 410 186.0
12' x 16'^ 366 x 488 2181/2"555 459 208.7
16' x 16' 488 x 488 2181/2"555 469 212.7
*Add 7" to overall case length for mounting brackets.
Overall case length dimensions ±1/4".
Specifications subject to change without notice.
Detail dimensional drawings, wiring diagrams and installation instructions available upon request.
Custom formats and sizes available upon request.
SPECIFICATION DATA
SUGGESTED SPECIFICATIONS: _________________________ projection screen(s), __________________ (H) x ________________ (W), electrically
operated 120 volt AC (60 Hz) not more than 2.2 amp. Three wire quick reversal motor especially designed for the purpose, to be ball
bearing and oiled for life. With automatic thermal overload cut-out and integral interlocking gears. To have pre-set but accessible limit
switches to automatically stop screen surface in the “down” position. Stop action to be positive to prevent coasting . The roller to be
of rigid metal at least 3" in diameter (to be used on screens 12' and under in width) or 53/4" in diameter (on screens over 12' in width.
Roller to be mounted on two heavy duty brackets equipped with self-aligning bearings. Screen surface to be flame retardant and
mildew resistant fiberglass with black masking borders standard. Case to be of wood, with double top for extra rigidity and strength.
Motor compartment to be metal lined. A section of the bottom of the case shall be equipped with hinges and connected to the drive
mechanism so that it opens and closes automatically with the lowering and raising of the screen surface. The door will lift to the
closed position where a micro switch shall cut off the electrical current to the motor. Balance of the bottom panel shall be pegged to
manual opening to provide access. Hinges shall be mounted to allow matching of the bottom panel to the ceiling. Specify Type 1 and 2
or Type 3 hinge, as required. Case to be furnished with a black primer coat, ready to accept final finish by others. To be complete with 3
position control switch with cover plate. Recessed installation requires access to motor. Screen shall be listed by Underwriters’
Laboratories and CSA.
Matte White: Seamless in all standard sizes.
High Power®: Available in sizes up to 9' x 12'. Horizontal seam required when both dimensions exceed 6'.
WHEN ORDERING, MARK APPROPRIATE SELECTIONS:
Select method of installation:
❏Type 1 and 2 - Offset or Flush Mounting
❏Type 3 - Extended Mounting
Select viewing surface:
❏Matte White ❏High Power®
Greenguard®and Greenguard®Children and Schools
Certified.
Options:
❏Extra Drop available to lower picture area more than normal.
Specify total drop at top _____ (black or white) or at bottom
_____ (black or white). 20' maximum total surface height
including picture area.
❏Single motor low voltage control (LVC) - external.
❏Wireless Remote Control for LVC.
❏Radio Frequency Remote
❏Radio Frequency Range Extender available
❏Infrared Remote
❏Key Locking Cover Plate for 120V or LVC Switch.
❏Key Operated Switch for 120V only (NOTE: cannot be used
with LVC).
❏No Borders (Black masking borders standard).
❏220 Volt (50 Hz) Motor.
WHEN ORDERING, MARK APPROPRIATE SELECTIONS:
Select method of installation:
❏Type 1 and 2 - Offset or Flush Mounting
❏Type 3 - Extended Mounting
Select viewing surface:
❏Matte White ❏High Power®
Greenguard®and Greenguard®Children and Schools
Certified.
Options:
❏Video Projector Interface Control - external.
❏External SCB-100 - RS-232 Serial Control Board
❏NET-100 Ethernet-Serial Adapter
❏White box (black standard).
❏White doors (brushed aluminum standard).
EXECUTIVE ELECTROL ®
Automatic Electric Projection Screen Model
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: [phone]
800-622-3737
Fax: [phone]
Toll Free Fax: [phone]
www.da-lite.com
e-mail: [email protected]

SUGGESTED METHODS OF INSTALLATION
TYPE 1 AND 2
Offset mounting, recessed above ceiling, for
plaster, dry wall or paneling. Door painted same
finish as ceiling.
TYPE 1 AND 2
Allow 1/8" min. clearance all around surface door.
Flush mounting, recessed above ceiling. For use
with 1/4" max. paneling or installation in existing
ceiling using molding around door.
TYPE 3
Allow 1/4" min. clearance all around surface door.
Extended mounting, recessed above ceiling.
For use with acoustical or other ceiling tile 3/4" thick
laid over door.
NOTE: Paint the same as doors and ceiling or
remove and replace with ceiling tile.
INCLUDING MOUNTING BRACKETS
9-7/8"
9-1/2"
8"
3"
FALSE TOP
3/4"
CEILING TILE
3/8" APPROX.
12-1/16"
FILLER BLOCK
3/4"
FALSE TOP
12-1/16"
1/4" MAX.
4-3/4"
3"
1/8"
2-1/2"
1/4"
PICTURE
SURFACE
MOUNTING BRACKETS
FALSE TOP
1/4" x 2"
LAG SCREW
SURFACE DOOR
ACCESS DOOR
SHIM
3/4"
11-5/16"
1/4" x 1" SCREW
& NUT INSERT
DRYWALL SCREW
“L” BRACKET
Project:
Architect:
Phone:
Contractor:
Phone:
Supervisor:
Phone:
Supplier:
Date:
Revised:
3-1/2"
12-1/16"
9-1/2"
3-1/2"
4-1/2"
FALSE TOP
MOUNTING
BRACKETS
3/16" THICK
22"
LENGTH OF FABRIC WIDTH
+ 26-1/2", ALL SIZES
“L” BRACKET
(8' AND ABOVE)
ELECTRICAL
OUTLET
FABRIC
HEIGHT x WIDTH
AS ORDERED, UP
TO 16' x 16'
Rev. 2/08
AUDIENCE SIDE
AUDIENCE SIDE
AUDIENCE SIDE
EXECUTIVE ELECTROL®
2-3/16"
36"
2-1/2"
(HOLE #1)
1-1/4"
(HOLE #2)