Daikin EKLD90P12 User manual

INSTRUCTION MANUAL
EKLD90P12
EKLD90P18
Difference in height installation kit up to 90 m

1
4
3+5
2
118 mm
4
3+5
2
EKLD90P12 EKLD90P18
EKLD90P12 EKLD90P18
2 3
1
1
1
2 3

EKLD90P12+18
4PW34861-1A
1
I
NTRODUCTION
This kit is an obligatory option especially designed for ensuring
optimum operation of the system in case the outdoor unit is installed
between 50 and 90 m above the lowest indoor unit.
C
ONTENT OF THE KIT
The kit includes all necessary parts and instructions for building the
difference in height installation kit into the outdoor unit. See figure 1.
N
ECESSARY TOOLS FOR PROCESSING
I
NSTALLATION PROCEDURE
Follow procedure steps as visualized in figures and as listed in table
below.
I
MPACT OF THIS KIT ON STANDARD
INSTALLATION PROCEDURES
The obligatory installation of this kit has no impact on:
■ Connection ratio of total allowed indoor unit capacity;
■ Equivalent pipe length between outdoor and indoor units;
■ Automatic charging of refrigerant;
■ Leak detection function;
■ Indoor unit installation conditions and the required field settings
resulting from these conditions.
N
OTES
EKLD90P12
EKLD90P18
Difference in height installation kit up to 90 m
Instruction manual
EKLD90P12 EKLD90P18
1 Brazing equipment Brazing equipment
2 Wire cutter Wire cutter
3 – Pipe cutter
Make sure to permanently cool the liquid stop valve when
brazing.
EKLD90P12 EKLD90P18
See figure 2. See figure 3.
1 Braze the standard installed
pinched pipe loose from the
tube that is brazed to the liquid
side stop valve.
1 Cut the standard installed liquid
pipe at the specified length
beneath the liquid side stop
valve as indicated in the
illustration.
2 Position the option kit behind the compressor as indicated in the
illustration.
3 Match the pipe-end at the
position where the pinched pipe
was brazed loose.
3 Match the pipe-end at the
position where the liquid pipe
was cut.
4 Match the non-return check valve (insulated part) and filter part of the
option kit against the insulation on the 2-way suction pipe behind the
compressor.
Fix the option part (both the non-return check valve and the filter
together) against the insulation on the 2-way suction pipe by firmly
strapping the 2 parts with the supplied tie-wrap as illustrated.
5 Perform brazing of the option kit.
Installation of this kit requires that the size of the main
liquid pipe be increased.

Zandvoordestraat 300, B-8400 Oostende, Belgium
4PW34861-1A