Dakota Digital HDX-96J-TJ User manual

Manual # 650789
HDX-96J-TJ
Dakota Digital HDX Instrument Installation
For 1996-2003 Jeep Wrangler TJ
Also Fits 1997-2001 Jeep Cherokee XJ
Your new HDX-96J-TJ kit includes:
HDX Display
Universal Sender Pack
Installation Manuals
Control Box
36” Main Harness
4x #8 x 1”
Sheet Metal
Screws
Buzzer

Manual # 650789
Installation
1. Remove the dash trim and instrument shroud by removing the screws highlighted below. Retain these
original fasteners for reassembly. Note: Disassembly for ’97-2001 Jeep Cherokee dashes will differ
from below.
2. Remove the factory instrument cluster by removing the four screws highlighted below, these screws will
not be reused, and can be set aside.
3. Attach the provided 36” Main Harness to the back of the HDX system. The optional Buzzer may also
be attached for audio feedback. Carefully run the other ends of these harnesses to the control box and
buzzer mounting locations.
Dash Trim
Shroud Bottom
Shroud Top
Note: The clip-in trim strip with vent along the top of the dash will also need to be removed.

Manual # 650789
4. After removing the protective film, carefully insert the new HDX system into the dash. Fasten the
system to the original mounting locations using the four provided #8 x 1” Sheet Metal Screws.
Reassemble the dash shroud and trim in reverse order using the fasteners retained in step one.
5. Refer to the main HDX manual for wiring instructions to complete the installation.
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov