Dakota Digital HDX-64P-GTO User manual

Manual # 650597A
HDX-64P-GTO
Dakota Digital HDX Instrument Installation
For 1964-’67 GTO/Lemans/Temptest
Your new HDX-64P-GTO kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
HDX Display
Buzzer
1. Remove the stock gauge cluster from the dash and save all hardware for reassembly.
(3) Block Off
Lenses
(3) 1/2" Pan Head Screws
(3) 1/2" Flat Head Screws

Manual # 650597A
4. Place the HDX system into the bezel, taking care to align all mounting holes. Secure the
three (3) provided countersunk screws on the bottom mounting points; move to the top and
secure the three (3) pan head screws.
2. Remove the stock gauges, separator plate, and lens from the bezel. The only item to be reused is
the original front bezel; the other pieces can be discarded. Now is a good time to clean or refinish
the bezel.
3. Peel the paper off the two block off lenses that
match the bezel and, on the back of the housing,
place them shiny side down in the two indicator
openings in the center. Use silicone to hold them in
place and avoid handling until the block off lenses
are secure.

Manual # 650597A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
Buzzer Connector
5. Connect the provided Main Harness and the Buzzer (optional for audio feedback) to the back of the
HDX system.
6. Re-install the cluster into the vehicle using stock hardware and refer to the main manual for
wiring instructions to complete the HDX installation.