Dakota Digital VHX-65F-GAL User manual

Manual #650625A
VHX-65F-GAL
Dakota Digital VHX Instrument Installation
For 1965-’66 Ford Galaxie
Your new VHX-65F-GALkit includes:
Installation
Control Box
CAT5 Cable
Universal Sender
Pack
Installation Manuals
Ford Speed Adapter
VHX Display
8X Push In Retainers
1. Installation of this VHX instrument system requires considerable modification to the stock
instrument housing. To reduce the chance of damaging other interior components, the wiring
harness, or any other part of the car, it is advised to completely remove the gauge housing to
perform the required modifications.
Switch Assembly

Manual #650625A
4. Ensure all areas are properly cut by placing the VHX gauge into the gauge housing and making
sure the back of the lens sits on the housing and is not raised.
2. Remove the eight (8) push pins so you can completely remove all the original gauge pieces.
3. All raised bosses will need to be trimmed flush while two sections will need to be removed.

Manual #650625A
6. Connect the provided CAT5 cable to the back of the VHX gauge.
5. Mount the VHX gauge to the housing using the provided eight (8) push in retainers.

Manual #650625A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
7. The gauge housing is now ready to re-install into the vehicle using stock hardware. Take care when
routing the CAT5 cable to the control box mounting location. Refer to the main manual to complete
the VHX installation.