Dancing Wings Hobby Tiger Moth User manual

Tiger Moth INSTRUCTION MANUAL
1.Fusalage Installation
3.Wing Installation
Tools Needed
Wingspan:400mm
Length:330mm
(X10)
F-6
F-1
F-1
F-10
F-9
F-8
F-5
F-6A4
F-7
A1
A2 A3
A5
A6
A7
A4
F-14
F-15
F-2
F-11 F-11 F-11F-16
F-12
F-13
F-19
F-18
F-17
F-3
F-4
A7
A3
A7
W-7
Down W-4
W-1
W-2
W-3
Down W-5
W-6
Carbon rod
Carbon rod
W-3
W-6
Up W-5
Up W-4
W-1
W-2
A5 A2
Insert carbon rod
A6
A6
A2
A5
2.Landing Gear Installation
F-20 F-21
Paint with black paint
Down Wing
Up Wing
A1
F-24
F-25
F-26
Heat-shrink tube fixing
F-5-1 x3 Stick F-5-1 on the
nose,and sanding
the nose shape
according to the
real airplane.
Install the finished down wing and up wing on
A3 and A4.Connect the middle part between up
wing and down wing with A1.Lastly,adjust the
wing straightly before sticking the joints with
glue.
Pls take down the parts from the board by knife,and
assemble them as per the procedures as below,we
suggest you to shape with 502 glue,and firm with
white latex.
Material:
1. Basswood
2. Balsawood
3. Paulownia
4. Fiberglass and others

4.Propeller Installation
5.Pulling Wire Installation Show
警告:
！内含小部件，不
适合三岁及以下
儿童使用。
WARNING:
！CHOKING HAZARD-Small
parts.Not for children
under 3 years.
Tiger Moth INSTRUCTION MANUAL
(X10)
W-7-1
F-23 F-22 F-22 F-22F-22-1
F-22-1
Here use self-tapping screw to fix buckle
on the fuselage, assist pulling wire.
Building Finish
Static Model Show
Pull the wire according to the
numbers in the picture,"1" is
starting point, "7" is finishing point.
Insert "1" and "7" pulling wire into
the reserved hole of bracket, tie a
knot and fasten.
Paint with black paint
Carbon rod
Stick W-7-1 on the W-7, and sand it
according to wing's radian.