Dancing Wings Hobby Fokker-E User manual

Fokker-E BALSAWOOD AIRPLANE INSTRUCTION MANUAL
A1
A1
A3
A5
A6 A7
A8
A9
A10
A4
A2
B1 B2 B3 B4
B5
B6 B7
B8 B9
B11
B10
B12
B15
B16 B17
B18
B19 B21B20
B22
B23
B24
B13 B14.1
B14
B25
B26
B5.1
C1
C2
C3C3
B14.1
A10
B18
B18
Magnet
B8
B8
B14
A9
A2
B2
B6
B3
B5.1
B5.1
B5
B5
B5
C3X2
C3
Magnet
B7
B23
B24
B26
B4
A1
A1
A3
B9
B1
A5 B15
A4
cut down
B20
Magnet
B13
B21
B21 C1 B25
C2
A7
B11
B19
1.Assemble the cowling
2.Assemble the fuselage
3.Assemble the wing
1.1 1.2
1.3
1.5
1.4
2.1 2.2
2.3 2.4
2.5 2.6
2.7 2.8
2.9
2.11
2.10
3.1
3.2
Soke first and bend the
cowling as per the
picture 1.5.
Soke first and bend the cowling
as per the picture
Glue the ribs on the wing
and take care not to put
both size in same direction.
insert the carbon rod,and put the
servo horn B19 in the middle.
Do not glue the carbon rod and servo
horn here.

B17
B17
B12
B22
6.Assemble the servo
7.Assemble the motor and display the C.G.
8.Display the receiver position
4.Assemble the landing gear
5.Assemble the wiring
3.3
4.1 4.2
Heat-shrinkable tube
A6
A6
A8
3.4
Guide button
a. Sew through the hole
on the bracket
b. Put the wiring
together through
the guide button
c. Pull the steel wire of the
guide button and drag the
wiring in the guide button.
tie a knot
Pull tight and
cut off the spare
Heat-shrinkable tube
Heat-shrinkable tube
linkage
不粘合
粘合
Roll up the counterweigh lead sheet onto the carbon
rod and cut off the spare.
CG≈27mm
Specification
Wingspan:420mm
Length:380mm
Flying Weight:≈30-35g
Suggested Motor:1104 KV3700
Suggested ESC:1S 5A
Suggested Servo:2g servoX2
Suggested Prop:4530-5030
Suggested BATT:1S 200-250mah
Suggested Radio≥3CH
Connect the vertical tail
to the end of the fuselage
with paper hinge,and glue
the horn B10 in the
reserved hole.
Adjust the tail wing and keep level,glue the
joints marked out in picture,adjust and glue
the servo horn and tail wing.
d. Pull one wiring to
the hole on the wing
and tie a knot,and
pull the other wiring
tight and keep
suitable length,finally
cut off the spare.